59 CJ. Stock parking brake assembly. I’ve read the Jeep service manual and Moses Ludel’s repair guide. I’ve installed new shoes. The manual...
No Longer for Sale Dauntless V6 Dual Batteries 8274 Winch & steel cable ~20g Aux fuel tank (30g combined) Hard Top T-90 D-18 Dual Exhaust...
With 3’ of snow on my roof, and the next weather pattern bringing in a mix of snow and rain, I thought it time to lighten the load on my roof...
Howdy, I removed the Saturn to rebuild the D18 on Dorris. That is complete, now for the OD install. I’m now installing the planetary gear into...
I’m doing my first t/c rebuild on my D-18. The previous person who rebuilt it for me did something wrong and the intermediate shaft destroyed the...
This is my first endeavor into engine work, so please be patient. The head gasket blew on my F-head. Getting the intake valves adjusted normally...
F-head Blew the head gasket. Figured out why. Now about to reassemble the head to the block. This is probably an obvious answer to some of you,...
Speedhut Gauges offering 15% off sale until June 1 https://speedhut.com/
I’m slowly restoring my ‘59. The rear axle and rear drive shaft are all that is left to do mechanically. ove been driving the Jeep and there are...
I understand and have read a handful of Dauntless engine threads. There is soooooo much information out there I’m hoping you fellas could help...
The installation procedure for wiring the factory horn on an early CJ5 was not clear to me, nor was the procedure laid out clearly here, or on...
A while back I picked up a used 6’ Meyer Model ST or C plow which fit Darling Dorris. As she is lifted, the bracket assembly required some...
‘59 CJ, stock master cylinder. Ive installed discs on the front (drums staying on rear). Installed 2lb RPV on front brake line from master. I...
All the saga continues. Took Doris out for a drive now that I finished the Roxor front axle and steering linkage. I am finding that the front...
Some of you may find this useful. I’ll be ordering a few parts myself http://alhansen.com/
I have read all of the tie rod flip threads, however a question remains; 59 CJ, 2.5 inch suspension lift, Mahindra Roxor Dana 44 axle. I would...
Last year I picked up an M416 to restore and then tow with my CJ for camping and yard projects. I figured now that its all done, I should post up...
After a couple of issues with my axle and getting advice from members I’ve chosen to attempt the Roxor front axle upgrade. I picked up the axle...
This will be my first axle tear down and restoration. Eventually I will do a full frame off, but due to issues with one steering knuckle, I’ve...
Please excuse my lack of knowledge. Upon replacing the ball joints in my CJ, I found that the hole where the ball joint slides into the steering...
Separate names with a comma.