I’ll loosen the motor mounts tomorrow and jack it up. The engine mounts are far forward so a little change in the front will be big in the back....
I am in the process of this swap. I have transmission and transfer case in. Novak kit. I ended up "frenching" the transmission mount into the...
Just pulled my T14 working unit out last weekend for a SM420 swap.
I didn't have the vacuum controls for the everything else except the cable Oldpappy mentioned. I bought a couple decent quality choke type cables...
This. The rochester is good and common to a lot of GM. The bushings at the throttle butterflies is a common vacuum leak as stated above. Redid...
Upon further review the main shaft is broken. The needle is broken too but I thought I might epoxy that. I would guess if anyone has parts this...
I have it apart, cleaned. The clock spring is not broken. How tight do you preload this when you assemble? I seems it will get tighter the...
10-4
Going to dig into an old speedometer this weekend. What grease specifically should be used? I figure red and sticky is out. I have seen mention...
Great information. Thanks to all!!
Waking this one back up. The kit is on the way from Utah. Some questions after a quick search here. (1) What speedometer cable did folks use....
I have Forceum MTs on mine. They are LT235/75R15. I'd guess they would have 16". I have had them up to 65 mph without issue. Offroad, just...
The forum is not accepting pics from me right now. I messaged you my phone number.
Thanks for that feedback. That’s what I was looking for. I’ll pony up for a selectable.
That is the LSD I have now, the stock Powr-lock. Its OK as long as you are on flat ground
I ran my own brake lines last spring. I know I removed one of the switch tees and ran a line to the back and front tee one piece. I'll look in...
I have a 30 spline rear axle. Also, I have the LSD carrier so I have to swap that anyway.
I presently have a limited slip in the rear of my CJ5. I'd like to go full locker after I get my SM420 installed. I had a buddy that had a...
I did my front axle bushing and brake pedal the same way, with a brake cylinder hone. plenty of oils and check it often.
Looks like the distributor gear is too big or not round.
Separate names with a comma.