Not mine. Just saw these on there. Was hoping for a 4 set.
https://www.facebook.com/marketplace/item/3242302052742670/?mibextid=dXMIcH
https://www.facebook.com/marketplace/item/2603134396505104/?mibextid=dXMIcH
It really doesn't matter. Find a spring that feels like good tension. Mine goes to an elbow under the carb.
https://youtube.com/c/TurnNBurn Have you seen this guy's stuff. He's been doing a lot lately.
I've been using the Edelbrock mico pump for a few years. I have a solex carb and don't need a pressure regulator on mine.
Would something like this work. It's a 1/4 on the end. https://www.amazon.com/dp/B074C6K2LW/ref=cm_sw_r_cp_apa_i_vv5LFb9XGGVH4
Image000001_04 by DirtRoad61 posted Jun 7, 2020 at 9:07 PM Image000000_19 by DirtRoad61 posted Jun 7, 2020 at 9:07 PM I made my own brackets....
Image000000_19 by DirtRoad61 posted Jun 7, 2020 at 9:07 PMImage000001_04 by DirtRoad61 posted Jun 7, 2020 at 9:07 PM Not pretty but works. Did...
F134
Petronix wires. Not a petronix points replacement for distributor. It's a full electronic one.
Electronic distributor. Was originally advanced as far as it could go. Slowly turned it down while driving till I had better results. I there is...
Started and idled good. Loses power and backfires after a few minutes of 3/4 throttle. Got better with less timing but still does it. Cant drive...
I have only had the Jeep for a little over a year. It runs good but seems very low on power. Over the winter I pulled the motor just to clean it...
Not sure. There's no markings to check. I have had to keep turning it down from where PO had it.
Plugs were new last year. The Jeep does sit outside under a cover.
I will test compression. Thanks.
Yes
10-40 Probably less than 1000 miles on plugs. Plugs looked good before last drive. Started acting up after 10 miles.
[ATTACH]
Separate names with a comma.