I am looking for an OEM badge, Driver side v8 fender, from left to right should be red, white and blue, I will take a passenger one and paint it...
Does anyone have the precise measurements for tail light bolt holes, this would be for the 3 screw lens stand off light. Thanks
[ATTACH] Can someone tell me what willys this fits and how much is it worth?
Classic enterprises sell a long (complete) version or a short version of a cowl support. I bought the long ones for $20.00 less than the short...
These are classic enterprises panel, great panel but it was already a little warped when I got it, now post weld in it’s even worse, not sure what...
I’m looking for rear seat install hardware. I know it’s a long shot and I know I could make some, but I would like original, anyone have any?...
[ATTACH] Can anyone tell me what year Jeep this mirror went on? this is pictured on a 1974 but I don’t think it’s stock, OEM ? Not even sure it’s...
Im looking for the best maker of windshield frames, Crown, MD Juan, (Omix-Ada, if they are anything like most of their parts, no thanks), or is...
Can anyone tell me how to decipher the repair manual, meaning I am trying to find the below body mount rubber sizes by looking up the part number...
Does anyone know which hose goes where?[ATTACH]
It is unclear in the TSM what heater hose goes where. Can anyone tell me which hose goes to block and which one goes to pump, it is my...
[ATTACH] [ATTACH] Does anyone have an original tail light for sale? Pics attatched[ATTACH]
I have a clearance issue on my alternator, unable to decrease belt tension and that ends up is with full tension almost maxed out, alternator...
Anyone know what direction these go?
Has anyone tried to use a c-clip or snap ring here, the horseshoe clips seem so rinky dink!
Does anyone know the correct lights for a 1974? are they the three screw shallow outside mount or the taller 2 screw outside mount? , pics...
Can anyone tell me if you can just put power brake unit in 1974 Renagade without mods, doing frame off resto and would like to just put power...
These are for the needle bearing side of the spindle but not the needle bearing seal, the seal outside of that! Has anyone had issues with the...
Anyone know who makes the best disc brake upgrade kit for the 1974 Jeep cj 5, and do you have to convert to power brake unit, and if yes do you...
Does anyone know what size or a part number for this, some of them I know were installed as a combination vent slash brake hose junction that were...
Separate names with a comma.