I bought this roll bar for my 70 CJ. Just started removing rust and found some numbers. I'm wondering if it is OEM, dealer installed,...
I have one of those aftermarket Speedos and just checked the speed against another car. I was reading 10 mph slower than them. Can I calibrate...
Can someone tell me the size of the nut on the companion coupler shaft on the D18? Dimension and TPI
Does anyone know where I can install an analog temperature sensor on my Dauntless? PO has installed a offy with only 1 out port which has the...
Can someone show me where the parking brake cable abutment bracket goes on my 70 V6 with the T-14? A pic would be nice.
Can the output bearing on the D18 be changed from the back side behind the Speedo housing or does the shaft have to come out?
I'm ready to install the overdrive on my D18 TC with a T14 tranny and have been told that I need to add spacers under the shifter mount on the...
Took my build on its first test drive today. Found that the T 14 makes a whine noise when decelerating in 2nd and 3rd. No noise in first or...
I put the Summit seats in and noticed that the passenger seat sits about an inch or so higher. Seats are both angled / reclined at the same...
What can be used to preserve the diaphrams on the heater box? Don't want them to dry rot. I was thinking of spraying a silicone into them. What...
Has anyone ever wired one of these replacement windshield wper switches from Walcks? It's for a 1970. My OEM only had 4 wires. I assume the...
Did Jeep ever make a padded dash for early CJ5's?
Didn't Jeep use bags for windshield washer fluid in early CJ's? I have OEM fenders, one with a bracket that looks like it was for washer fluid....
Does anyone know if I can install a universal choke kit on my dauntless edelbrock 1406 or do I need the special kit for the 1406?
The 70 CJ I am rescuing sat outside for nearly 30 years, uncovered. The PO did have the shifter covered with plastic to keep water out and the...
Has anyone tried these? Any tricks, technique, hints, or waste of time?
I'm working on my 2nd 70 CJ5 Dauntless 225 project. My first one was original intake and 2 barrel carb. It had all the power and torque I...
Here are pics of where I started and one in-process. I'll try to add more once I get this camera to work (microsoft).[ATTACH] [ATTACH] [ATTACH]...
So, I have owned nearly a dozen CJ5's over the years including a 70 model exactly like the one I just purchased as a project. I know there were...
Surely the diaphrams in the flappers on my 70's heater plenum must be dry. Should I spray some kind of silicone spray in them to keep them going?
Separate names with a comma.