Benn using for farm work some, dragging logs, hauling wood pulling trailer. Works surprisingly well down low under 2grand. Couple short road...
Still. working out bugs, viedo to come. And yes I'll drive it as my daily driver! When engine was in car it got drove daily, unless rain or snow....
Any idea what this thing weighs? 5000lbs?
Repaired cable end. Went up from 71s to72s in front. 31 to 35 squirt. No more flat spot! Close enough till exhaust work done, have to retune then!...
Test after spring install! I put a 5400 pill in the shift light, son and I headed to county line and back(1/2mile straight). Turned around at...
And, me, I kinda always wanted a hornet! So many jokes bout ,where's my trunk! Had lots of good times in my Amcs, didn't bother me that others...
Buy it! The 401 in my 3000lb gremlin was Explosive @ 2500rpm. Showed many a blue oval and bowtie my tail lights! And with the t10, it was the...
I've had my share of problems. Oil line Fire, the worst(all burnt wiring repaired except fuel gauge wires),727, pan leaks,(mopar gasket...
My RC ,YJ, 2in lift springs with 1 bottom spring removed, on a light 134, 70 cj5, are great, off road, really rides like atv. BUT on road, above...
The Ferrell goes inside the nut, around the tube, then as tighting up it taper shrinks around th e tube, bites in and seals (most times). Fairly...
A poster on another forum I belong to, a plumber, said he always pre crushed the Ferrell On the tubbing with an old fitting, before final...
Yes the Ferrell was in right flat end against nut, cone end into fitting, at least 1/4 in line in past Ferrell . Nut was tight, threads not...
62, built over 100 engines, first fire! Oil gauges used to come with copper line. To save 1.25$ they now come with poly line. I spent extra time...
Found the other end of wires, 8pin green connector, hooked to nothing . I took out. Maybe some AC control ? The whole system long gone.
Removed my grab hdl to die black to match dash. 3lb, heat sync thing with several tiny wires fell down. What is this? Can't find in my wiring...
I have no idea of the mechanics going on inside? I leave that to the Pros!
I have contacted Hughes for recomandations.
Will a 2500 flash, 2100 stall, still pull away from stop at low rpm(1000)or less? 450-500hpish, 401, pulls Hard from 2-2500rpm-6000rpm , 727, 3:55...
Thanks, new signal switch and upper harness. It has to be working cause the front lights come on, when switch is left,or right. Should the flasher...
Should the new style electronic flasher not flash with just the front lights on? I remember the old mechanical type would not blink when tail bulb...
Separate names with a comma.