Here's what it should look like, maybe itll help you out
Local upholstery shop might do it but I haven't been able to source the neoprene material in the pattern I want myself. You might fare better.
I was wondering this too. Give cover king a call and see if they'll do it.
Lol that page is either experiencing problems or not set up for mobile devices
You read my mind! Novak recommends changing the pressure plate when you upgrade to the hydraulic link. So I'll keep it stock but make that $120...
Damn. It's ironic because the truss would fit well with the coil overs, but even a hybrid setup would be expensive and just put them in front. I...
Good stuff thanks I'll check that out. Might leave the axle for later until I can find a good deal in a scrap yard on a D44 or maybe a Ford 8.8.
I did some talking with a few dudes and priced some things out. It's still possible (maybe even a hybrid setup) but we should definitely talk...
Makes more sense now. I have a roommate who is a mechanic and a few shops nearby should I run into anything unexpected. Welding isn't a problem....
Good advice on the transmission. I would like to leave some room for bigger wheels and tires later, without it being ridiculous for these 30's....
It seems to be important to lay it on in several coats, and obviously prep the surface well. In addition, they recommend you use their...
I've read it, thanks. That's where I got that bit of info. on the older models. Definitely a good reference, though. Dont recall the clutch...
I'll check it out but tbh it was probably a stupid idea to mess with the engine right now anyway. Only brought it up because my neighbor...
Suggesting something else, specifically? And about the transmission...from my reading I've learned that some T18s wont fit, but I believe they're...
I uploaded some files for reference. I should probably start a new thread for this but in the meantime since I mentioned the T18...can someone...
Stoked ya it seems like a pretty awesome way to go.
Assuming you're speaking to me....maybe. I've got access to a compressor large enough for the job but I'd have to trailer the tub to it. The gun...
Check out Novak. I rebuilt my T176 with their kit and also used them for a hydraulic clutch conversion. Not only will they have the parts you...
I've been pondering this a lot and think I'm going to prime everything and then dip the jeep where it isn't raptor lined. It's completely...
Gents, A little background: I'm tearing down my 80 CJ5 (Id like to bore out its 6 cyl engine a bit) since I have a lot of stuff I didnt like...
Separate names with a comma.