Found this old thread...exactly what I'm looking for. http://www.earlycj5.com/xf_cj5/index.php?threads/97884/
Anyone have a good diagram for a basic bench start for a V6 just so it runs? I'm sure I could cobble it together, but if someone has already made...
I think you just need to add a little of the free brake fluid your friend provided and you're good to go!
Good question, the bracket to the motor mount seems a bit flimsy.
Transfer Case to Engine Mount by dsthomas350 posted Jan 21, 2022 at 9:33 AM Upon further review, there is evidence of an old motor mount inside...
How timely that this was posted, I just put a brand new transmission crossmember with the round bushing on yesterday, nothing seemed right. Now I...
O'Reilly wasn't much help, all they could find was the original part, 1/2X20 (not is stock of course), but was no help in identifying another size...
Not sure, I'll take it over to O'Reilly and see if they have different sizes. I made the mistake of buying all 20 new studs, the rears worked fine.
After pressing out the front studs, the new ones won't hold in place. Wondering if I just trashed the hub? IMG_0582 by dsthomas350 posted May...
After some cutting and grinding I think I have the original bracket. Will need to tack and weld it back together. IMG_0570[1] by dsthomas350...
After taking the frankenbracket off I see that the PO cut the cable end off of original bracket and welded in some stock to make it longer. No...
Yes, if you have it, I haven't even found an image of this part.
My Google skills must be slow this week, for the life of me I can't even find an image of one of these. Do you have a source?
Upon further review, I believe the clutch cable is correct for a T14. But the cable bracket on the transmission looks out of place.
Couple weird things going on here. Looks like I have the wrong crossmember, it's missing the cup for the transfer case mount. I also have the...
The piece I cut out is pretty rusty on the inside as it wasn't sealed well at the bottom. It's also not large enough to have the proper bend at...
Well I finally got around to removing the welded on panel from the passenger side. There is some metal underneath, but not much. Decision needs...
Nice Nice job on the girdle. Gives me some ideas on how to do mine.
When I get to that point I'm totally prepared to have to make modifications/adjustments. But I'm already thinking of how to do them.
I think I got the same deal on the rear floor as you did. If I recall, the front floor was around $540 US.
Separate names with a comma.