Despite living in the Colorado mountains, I haven't taken my CJ 4wheeling, it's more of a (short) commute to work vehicle. But I do snowplow with...
I installed one of these on my 71 as well after I removed a PO's home-built linkage catastrophe. It works great and has a lot of adjustment. One...
The original Ross steering on my 71 CJ5 had gotten so bad, I could barely keep the Jeep in TWO lanes, let alone one lane. Completely unsafe. So I...
I like Herm's design. And I realize that he makes this product to 'fit' many different years and models of Jeep vehicles few of which are...
Scott, That's the money shot!! Thank you!! It looks like I'm going to have to go the header route like you did. I just don't see a practical way...
Hey Scott, Thanks for the pictures! Did you use the original steering post/rod? Did you have clearance problems with the stock exhaust manifold?...
Lilbuff63, Thank you very much for posting your pictures! Those are the only pictures I've seen of the actual steering links between the steering...
I haven't re-installed my radiator yet, but before I removed it, (to my eye) the radiator looked like it would not have a clearance problem. With...
Hello to everyone! I hope this post finds you well! I'm reviving this thread (most of the old threads are missing pictures) because I'm having...
Yes. I actually got lucky the first time I installed the u-joint (50% chance if you're not paying attention, like me) and I installed it...
Two other important things to remember when changing the original Dana 27 u-joints. 1. The easiest way to change Dana 27 front axle u-joints is...
I just did this upgrade. Call Gabe at Northern Drivetrain, he just fixed me up with a 1310 yoke for the front axle. Here's the thread with his...
I did not mention where I got my new driveshaft with the 1310 u-joints in my original post. I stumbled on Tattons website through Ebay and ordered...
The original u-joints are still available, I was attempting to install new u-joints on the original driveshaft when I bent the yoke. The word that...
Not sure if this has been covered in another thread, I did a search and could not find anything. I've been working on a basket case 1971 CJ5 for...
I have a 71 with the same set up as you, and I had the same trouble with the clutch. I ended up ordering an adjustable pivot ball from Summit....
For those of you who don't have access to a ten year old, or like me, you have a ten year old daughter that wouldn't be caught dead touching a...
I just read your entire thread. I'm very envious of your fabrication skill and attention to detail. You do fantastic work!
I bought a 71 with a newly rebuilt V6 that had a similar problem with the clutch. I ended up pulling the motor instead of pulling the tranny to...
Separate names with a comma.