Thanks a lot Tim. I will see if I can get them here at a reasonable cost. I get what you are saying about the shocks. I don't want to treat them...
Hi Tim. Strange as it sounds but the originals were 12front and 7rear. During the rebuild I could see that it is still the original bushings, and...
Good afternoon to you all! It,s been a long while since I've posted anything on the forum, but my forgotten password is sorted out now. I'm...
Well, that is the one thing I'm not sure about. I have asked the shop who overhauled the motor to pay attention to the parts going back in the...
Thanks for the info. I will check all of the above. Can any damage occur with the clatter? Yes, that "NOTE TO SELF" is duly noted! Very cross...
I,ve got a noisy lifter after my rebuild. The engine was completely overhauled except for the cam and hydraulic lifters, and it's running like a...
I envy you pathkiller! I don't get to Namibia and Botswana often enough. In December I'm doing a desert trip again from Luderitz to Walishbay....
O.K. Here are the last couple of pics to the point where I'm at now. I really started to have some fun, as everything was coming together...
All that I can say is WOW!!!! What a drive. I love this Jeep to bits, and what a rewarding experience to have done a project like this!!! I will...
I installed the engine, drivetrain, exhaust and all of the brake and fuel lines first. Basically the whole chassis to run it in gear on jack...
Any news on that rollbar hight?
No problem, thanks!
I need some measurements for my rollbar. I just need the total height from the floor level to the top of the rollbar. Appreciated thanks,...
Also be carefull that the whatts of the bulb is not to low. If it is, the alternator will only excite on higher R.P.M. This happened to me, but I...
Thanks Bigjohn. I can get hold of a temperature gun, so I will do that as well, it will be interesting to see how accurate my gauge is. It turns...
:rotflmao::rotflmao: I got same hit!
O.K, I couldn't wait. I took out the thermostat, and the only markings are the following. A160 and 9186. Does this mean 160 deg F? Also, does the...
Thanks guys. I will have a look at the thermostat the weekend.:stout: I fully agree, rather stuck open than stuck closed! Cheers.
Hi all. I'm a bit worried about my engine temperature. I think it's running too cold.If I remember correctly, the correct thermostat is...
It also sounds like a bad ground to me. When I grounded my chassis and engine, I first cleaned all the paint off for the cable lug to sit on bare...
Separate names with a comma.