Hadn't gone to them yet... typically use them as a last recourse to try and support Jeep specific retailers. However, in this case, they...
Must be me... as usual. I can't find an XRC Bumper application for even a late-model CJ: http://www.smittybilt.com/product/index/34.htm Looks...
Was wondering what you guys used for a source for replacing the window "felts" on these old hard tops. I see a couple of companies sell kits....
+1 - glad someone remembered to dig this up!
Good thought... I'll check that this weekend. If I recall, the rubber was pretty done on the seal.
Would have to find a non-contact thermometer. I'll ask around.
Old coolant was thick, but a good green. The radiator isn't pretty on the exterior, but looks pretty clean on the inside. I don't have any...
My temp gauge liked to peg itself out beyond H and did so fast... so I figured it was time to replace coolant, temp sender, and 192* thermostat....
Ouch. Tubs that look like that make me feel much better about my project... that's a bummer. The PO on mine had carpet as well... but it was...
:beer: There should be a "Stupid Question Club." I'd join... heck, I'd be a charter member!
That will go on the list! Looks very handy. The experience on these brakes keeps evolving. I bet you guys just read my ramblings and shake...
I tightened down everything I could in that linkage and greased it. With the tightening, it is staying where I put it, but one can still feel the...
Alright, a little evolution on this problem and my understanding of it all. Had my father over to talk it through and he's much better at it than...
Alright, got in over my head here. I just rebuilt by rear brakes about a month ago (new drums, shoes, fluid, wheel cylinders, and system bled)....
Most auto parts stores should have one in their loaner/rental tools.
That is some fine looking work, sir. The new hat channels are great. Maybe I need to trailer mine up and haul it down to you for some love. :D...
I guess I'm a bit in the dark on the expensive shipping. UPS will put an 80lb transfer case into Mexico for under $400.* Perhaps you need to...
Looks very familiar (really similar to mine). I'm going to go away from the red (which was "Trans Am Red" in '74 according to the factory color...
If that carb would match up that wouldn't be a bad deal as well...
And affordable! Thanks for the direction guys. I'll peel it apart and see if there is something I can do for the time being... and wait until I...
Separate names with a comma.