Facing all the carb and ignition woe go away with a simple diesel swap. That being said, one other huge problem with ethanol gas is it is...
It will
Your speedometer is driven by a cable from the transfer case to the speedometer. Id take a look at your motor and trans mount. It sounds like the...
the cool thing about Willys is the body mount rubbers were originally made from pieces of car tires. So you could collect a life time supply along...
If you are set on a cj5 tank, Willys used the same floor pan in cj5 as m38a1 with a sheet metal piece spot welded in place of the tank well. On...
I have another testiment to pertronix, not on my jeep , I solved that by swapping in a diesel. My Pertronix experience is with my Massey Ferguson...
nice job on the jeep and also your TR6! Two suggestions, one try a needle scaler to remove rust, the work great for removing off road concrete and...
#4 and# 6 jic can be adaped to inverted flare by using steel tubing with a Parker nut and sleeve. Use the inverted flare to attach to the valve,...
depending what is wrong with yours they are not terrible to rebuild. They rust out under the doubler panel on the rear, if thats the case you can...
I used Herms kit on my M38a1 with a power steering box from a Ford Ranger. I have had several rigs that I swapped to Saginaw steering. Done...
I have one of the larger HD flat top tool box that I bought when i retired. I spent 35 years prior being a field mechanic on cranes. For a home...
Have you considered a Kubota v2203 di diesel? They fit into an older willys pretty easy, can make pretty good power with the addition of a turbo (...
Your build looks incredible! One question, where did you find your shift boots? Especially the transfer case? Thanks
Howdy, from your pictures your body is repairable. One other very good source of repair panels and hat channels (the supports under the floor) is...
Howdy, Ive had lot of rigs with d18 tc and what has worked for me has been #3 permatex on the paper gaskets and on both sides of each shim,...
I went with a saginaw pump from a 75 vette, fabbed a bracket, and used a Bobcat 743 dual crankshaft pulley. It works ok. The Kabota engines are...
re:termin8ed The unit is always turning but when it is in direct the planet carrier is locked to the shell by the synchro so the carrier turns...
One possibility is the box leaked and rather than fix it the Po just filled the box with grease. I rebuilt a swing box on a crane that had been...
It could have been a lot worse! We were coming back from playing and my buddy, who has a giant diesel pusher ask if his park brake was smoking...
I have a 53 m38a1 that Im running a Kubota v2203 with a kkk 03 turbo, a SM465 trans, a d18 transfer case with a Warn od, 4.11 gear ratios in a...
Separate names with a comma.