Fairly comprehensive video on how to machine a Dana 18 intermediate gear for tapered roller bearings if anyone is interested in the process......
I am not sure if anyone else has experienced this, but the last 3 Dana 18 rebuild kits I have ordered from Novak included intermediate gear thrust...
As most of you likely know, the T14 transmission is not compatible with the small hole (3 5/32") version of the Dana 18 transfer case due to the...
Bought one of these small top-handle chainsaws on ebay for under $100 shipped (link below). Yes, it is made in China, but seems pretty well made...
While waiting for the motor for my 68 CJ5 build, I decided to start another using spare parts. I have the following (with little or no cost in...
Wasn't sure where to post this, so feel free to move it if needed... Quite a bunch of industrious and inventive folks here (kind of have to be...
Working on a 4.3/SM465/D18 build and would value some feedback on the two output shaft options. Talking here about the transmission output shaft...
Quite a few posts lately about water in transmissions and t-cases. Being open top vehicles and often parked outside, water running down the...
In rebuilding my propeller shafts ('68 CJ5 V6) I discovered that one of the slip yoke seals was rubber and the other was cork...both likely...
I have two different variations of the 15x5.5 steel wheels. Both have the 3 hubcap bumps, but some are flat/smooth at the hub where the lug nuts...
Wanting a tall narrow tire set-up for my '69 Cj5. I have a line on some 16 x 4 1/2" NOS steel wheels in nice condition. The CJ is mostly original...
Anyone know off-hand if there is any difference in the transmission case between the early T14's and the later AMC T14's? I know there is a shaft...
This hard top has been on local CL (fairly local, 2 hrs away). Says it is for a '68. While I do have a '68 and a '69, the '69 is the one I'd...
Rebuilding the rear diff on my 68 CJ5 with original Dana 44 and Powr-Lok and ran into a discrepancy in the FSM. It states in the text that...
I was curious about converting a Dauntless V6 oil bath air cleaner to paper element just for simplicity and cleanliness, but didn't want to modify...
Anyone happen to have pictures of their Jeep painted Marlin Blue? I have a 1968 CJ5 that was originally a lighter blue or green (Empire Blue or...
Doing some of the body work on my 68 CJ5 tub and had a question about the front-most mounts on either side of the tunnel. Anyone have a good...
I have pretty much been flying solo on my Jeep project up until this point, but decided to share some about my build. Found this forum recently...
Separate names with a comma.