I need to attach these V8 badges again to the painted tub. They are the originals and pretty heavy. Any suggestions or thoughts on what has...
I have the original 16” wheels for my Jeep (‘72) but no tires on them. I’d like to do something like the pic attached. What size(s) 16” tire...
Got mine from Classic as well. No problems at all. Fit perfectly on my ‘72.
Just coming back to report that I was able to remove the original cross from the upper joint surprisingly easily once I brushed away the old...
‘72, manual steering The u-joint connecting my intermediate and steering column shafts has play and needs to be replaced. The TSM says this is...
‘72, 304 Went for a short drive around the block. Was the first time she’s been on the road in over 30 years. Felt great after this 5+ year...
Well, back for Paul Harvey’s rest of the story. I adjusted all the wheels to full stop again, then backed them off following TSM instructions....
This is the procedure from the TSM that I used to bench bleed the MC. Fashioned the curved rerun tubes as described. The bubbles eventually...
Regarding the residual check valves, I would assume they are present in the MC behind the tube seats as the diagram in my TSM shows since what I...
I’ve bench bled the replacement MC until there were no more bubbles. I’ve replaced all the shoes, springs, and adjusted them to decent...
Jack underneath it and then a lever putting some pressure against the knuckle and axle grabbed it enough for me to torque it down. Thanks so much...
‘72. Pressed in the new ball joints and installed the knuckle. Upper ball joint went perfect. Torque to spec. I can’t seem to get the new...
With a fresh set of eyes this am, what I believe has happened after studying the new part is that when I pryed them out, all that came out was the...
Thanks. I see the function part, but only a standard looking seal popped out. It’s in the pic on the right. I can’t get the new one with the...
I’m trying to replace the inner axle diff oil seals inside the diff on the front axle of my 1972 cj5 Dana 30 (at least I assume it is a D30,...
‘72. Anyone have a part number or option for the clips that retain the parking brake cable in the pic? Looks like I need three total and they...
When installing a drive shaft, does the shorter, sliding end connect to the differential or does it even matter? I may have mine in backwards.
My original gauge cluster is beyond saving. Not reading great things about the $100+ Aftermarket ones from Omix, etc. either. I think I found...
I’ve got a switch like the style attached. It has two positions as you pull it out. I wired it like the original one was, but who knows if that...
Anyone know if this one by Crown (J5350061) will work for my T15? Most websites say “76 and up” or “T18 and up” as usual. I like the studs on...
Separate names with a comma.