I didn't find any alternative oils recommended by the oil expert I found that were substantially lower priced in the quantities I will probably...
I am not determined to not follow the advice here to use 80w90 gl-4. I believe you: I'm already convinced that oil would work fine. I'm simply...
Someone on the Net who is known for being a specialist in oils told me not to use GL-1 80w90 gear oil but that a Diesel 20w50 would give gl-4...
My Jeep leaks a lot. For all I know, it could leak gallons per year. And the reasonably priced 80w90 GL-1 oil I have is really thick and gooey...
My transmission & transfer case leak and so I don't want to put expensive gear oil in them. In about a year, I'll have the time to re-seal them...
It appears that 80w90 GL-5 destroys the synchros by peeling off metal from what I've been reading. That begs the question. What is different about...
I can report that a screwdriver stuck against one end of each clip which was then whacked with a hammer did work to get the c-clips off. I had...
When both wheels were jacked up, the wheel I tried to spin by hand turned super easy while I used only my wrist and one finger to spin it. This...
With both rear wheels jacked up, I can spin one of the wheels using just one finger and my wrist, almost no effort at all required. But when I...
Thanks. I think I'll do exactly that, buy gaskets and open up differentials and look inside & change all the oil. Not sure I would know what a...
Thanks. Timgr: Did 1967 CJ-5s offer a limited slip differential as original equipment? How can I tell if my differentials are limited slip...
I read the oil threads you guys pointed me to. I think I know what to use now, but I'm not 100% sure because there was more than one opinion on...
What type of gear oil is used in the 1967 Kaiser Jeep CJ-5 transmission, transfer case, rear differential, front differential, and steering...
What's the best way to remove the driveshaft ujoints on my 1967 CJ-5 that has the 225 V6 engine? Bang out with hammer & pipe? Use a "c-clamp"...
I just looked on the Moog website for information on the Moog Precision 361 which you recommended for the front driveshaft and according to the...
My CJ-5 had the 225 V6 (which I replaced with a GM 252 V6 which was almost a drop-in replacement). Thanks for that information. Glad I didn't rely...
I cleaned things up and you are right, all the u-joints on both my driveshafts are held on by c-clips on the inside.
I edited this post from what I originally posted after doing a lot of research. My Jeep is a 1967 CJ-5 made by Kaiser with the 225 V6 engine....
My Jeep is a 1967 CJ-5 with the 225 V6. When I inject grease into the U-joints of the driveshafts using a grease gun, I see grease coming out of...
Separate names with a comma.