I've run into grinding noise occasionally on Chevy Big/Small block and it's often due to the starter gear being too tight to the flywheel or...
Stay away from the OEM JK lights (if you really want some I'll send you my old ones just pay shipping), I replaced them with Hella H4's ECode in...
Thanks for the info, I'll change it this week and see what happens, the cable I bought is from Omix/ADA is there a recommended/better cable for...
My '71 not sure of the build date, is under the seat, everything looks original so it may have been added later and the one under the rear removed.
It's worth whatever the right guy that comes along will pay for it, I paid $5000.00 for mine but it was in very good shape (almost no rust) and...
I'm in the process of trying to get my speedometer working properly, it was bouncing around a lot (0 to 60) I removed it and checked the gears...
I bought one for a 2000 Grand Cherokee with the 4.0, fit right in there.
We had some '67's, 24 volt in the Canadian Army that had the floor mounted starter switch, may have been a military option in later years.
Not sure, the way it's mounted and the attaching hardware looks factory, and it was originally the same colour as the body.
Ok, thanks, I found a picture of it online now, I don't have a box surrounding the heater core. I'm sure I can build one or find one if I decide I...
There is an air inlet behind the grill on the drivers side with a round flange (didn't measure but about 5" across) inside the engine compartment,...
The tube was still attached to the round metal plate, so I put a little silicone around it and pressed it back in from the bottom, don't think the...
traffic ??
I know this is an old thread, but I took a piece of pipe that fit over the horn tube but inside the bearing race and drove the tube out, then...
Makes sense.
Overlooking the best way to do it arguments. I got the steering box back together and in today, works great, virtually zero play in the steering,...
Thanks, I'll take some measurements and look at those pins. Any particular reason not to remove them ? I can't see any problems, they are still...
The steering on my CJ was very tight and felt like it was binding in certain areas, I ordered the parts to rebuild it and everything came in so I...
'71 CJ5, Dauntless & '13 JKUR
I just picked up 5 15 x 6 white steel spoked trailer wheels low offset, will paint them black or body colour, I was looking for OEM one's but...
Separate names with a comma.