Been a few years since I posted here but i did these over the summer. [IMG] [IMG] I used my MM250. Get the anti coning rings. I didn't...
no there still runing in the forward direction there just runing on the coast side of the gears ( like if you where backing up ), this is what...
if you flipped the axle over or the center section then it will run backwards. to get a HP 60 or 44 you need a front from a ford, jason.
i just weld some expanded metel mesh ( i think it was the 1/2'' <> stuff ) to the peddle, or like 53flatty said self tapping screws, jason.
i like hiems, they where simple and easy to install, drill the hole out to 5/8, got a combo hiem 3/4 shank 5/8 hole made a tie rod and was done....
if i am runing spray, pulse or duel shield core wire then its pushing the weld, stick and short arc pulling, of course these paramaters are in the...
having rolled in my 57 willys with a pipe cage ( tied into stock ) i came out fine, and it was not just a flop it went over hard onto a pile of...
run the 205 RIO, you wont regret it. i installed a divorced 205 in my buggy, i ground down the shift rails so i can get front low range, i can do...
i would use the LSD carrier insteed of an open one they are alot stronger and its free, jason.
could cut the and weld the plate insteed of having one bent, could save a little in the over all cost of your build, jason.
like i said early they are not ment for ON THE ROAD, they will vibrate and kill your seals. its there over all thickness 1/4'' wall and where...
thanks for linking here and this is not my post, jason.
not realy sure how to link it but i was the only one who posted to it with the same info here, its under the jeep hardcore section 1st page ( for...
this was posted on pirate and i suggested using a 420 out of a large truck, i have one that has a input shaft size of 2'' thick and about 10''...
they are extremaly strong you will break your ends off before you bend the shaft, i had one on front of my 57 and i landed hard on a rock and...
interals are the same and the shift tower but like said all ready the inputs and outputs are very different, my friends CJ-7 he did this swap and...
hey clay i did the swap on a OD green 57 willys about 3 years back the jeep is in southgrafton MA, i am closing my shop on depot street and moving...
thanks i will e-mail him and if you find out any more info let me know, jason.
i will get a better feal for what i am dealing with when i pull the moter next month, for now i am just getting info. i would like to go to a 420...
i have a mint 3.8 fuel injected motor that i was think of putting in my flatfender, i have the factory 3.8 wiring harness, a bellhousing,...
Separate names with a comma.