Yes, I have them around 1.5 turns out. anything lower than that and it won't idle
Alright, ordered a new (rebuilt 2g). Old on is #7027082, new is 7027089. Swapped them out, seems to run better but is really rich. Pulled the main...
Let me know when you get over this way. We'll go to lunch or something. Still working on a carburetor issue, maybe I'll have it figured out by then.
Hate to hear it Matt. Good thing you weren't going down the highway!! I just put new bearings in mine and didn't even think to look for cracks....
[IMG]Added a picture, you can see where the notch on the distributor body is. I had to notch it in order to get the proper alignment between the...
Yep. I went through the same ordeal a couple years ago. Bought an HEI off of ebay for cheap. the guy said he had rebuilt an oddfire HEI, but found...
Thanks for the response Walt. Gives me something to think about. I don't think the whole fuel bowl is draining. If I don't crank it after I warm...
I'm having trouble with my engine starting after I run it to operating temperature and then let it sit for longer than 10 minutes. If I try to...
I also found that one of left port in the intake that heats the base of the carburetor was completely carboned up, no passage at all. I guess...
You are correct. Two lobes were almost completely gone. I don't really understand what I've got going on. Oil pressure runs around 50psi at...
I picked up some hyperlube zinc. And it's getting a new cam and lifters.
Pulled my old cam out this weekend. Suspected something was going on. I have attached a couple pics of worn cam lobes. I know it will affect...
I see you're in Pine Ridge, Ark. Skyjacker is in West Monroe, La. I'm not sure what shipping is, but I went to their shop and bought a full set...
I installed Herm's kit a couple years ago and it seems to be as quiet now as it was after I first installed it.
What is the reccommended fuel pressure on a 225, 2G, mechanical fuel pump? It does have a return line going from the filter back to the fuel tank....
When I swapped to HEI, mine quit working. I don't know if shorted something or what. Bought a new one and it worked fine. It's a sunpro also.
No, its a manual choke 2g, choke wide open. It will start right up if you try it as soon as you kill it. Anything over five minutes and it's...
My 225 starts fine when its cold, but after its up to temp you really have to crank it over for like 5 to 10 seconds to get it to start. If you...
It may have been low and not reaching the seal area before. I know mine will leak for a while after I change it or over fill it.
Mc Ruff, I'm looking for some 5* castor shims and was wondering if You Have any available, if so how much you get for them? I just swapped a Dana...
Separate names with a comma.