We had a reeeealy bad run of boxes from Redhead over the last year+. 7/10 of them were either faulty out of the box, leaked, or failed within a...
First one sheared splines in Moab, and I swapped it out with my spare. The spare was never intended to be in for very long because I didn’t like...
She’s back home! The move is finally complete, the garage finally has room, and the roads were finally dry enough to tow her home from the storage...
I loved my 292 in my dump truck. It would chug down to 200 rpm and run at any angle. The first thing to go though was that exhaust setup. What a...
:pickme: …but I doubt you (or anyone) would want to go through what I did. :D The Chevy is a solid platform. Just don’t cut the hood to make...
Early 70 has the hood reflectors
How about a good repair job? Take it to a reputable shop, they should be able to make it look like it never happened for cheaper than a replacement.
“You pay me 5x what this is worth because I don’t know what it is.” I’ve never understood that logic.
I’m trying to imagine why that would’ve happened. Was that bolt head smeared like it hit a rock?
A short shaft with a D18 is easier than a short shaft with a D20 or D300 due to it being a few inches lower output. You’d probably need a double...
A couple of zeros too many
What is wrong with people.
*had They went through a chemical change at some point, turning that white oak into iron oxide.
The hood from my 5 through college… Bonus points if anyone remembers what back-of-the-magazine advertisement the girl was from. [IMG]
Couldn’t agree more.
Sounds like a bit of a flip. They probably have no idea.
+1
[IMG]
It’s crazy to me that 10-20 years ago, he’d find it hard to get $3200 for that.
With that much time and money put into it, and this is the best they could come up with for the rear wheel opening. :n: [IMG]
Separate names with a comma.