I would like to have one too. I'd actually prefer a half cab. just dont know if they would keep you any warmer. I'd pick up either one of them for...
awesome looking jeep. you have done a great job with it.
if you have enough heater and a decent soft top i would think it would work out as it is. i know i read somewhere on here about someone putting...
Re: CJ7 1975 PRice Well, spent 20 min inspecting that pricing guide. thats wild. back then the cherokees were more desirable, and the CJ was...
that sounds familiar..when i picked up the 75 ive been working on all i had to do was fix the lighting and replace the spider gears in the rear...
Ive got good news, after having loads and loads of problems with carbs i finally seem to have one that is working right. i have been through one...
at this point the name fits pretty good. its low, and with no tires im sure its real slow :D
Ive got one i pulled out of mine, even got the key with it. Not sure of the condition of it, i pulled it almost as soon as i got the jeep. I...
Well it turns out that since it took me a while to install the kit i have gone past the thirty day return period. I did not measure the shocks to...
Thats what i did on my home made wiring job, the only problem i would see is it might loose some voltage going through the switch. I dont think...
No one has any thoughts on this or sees any problems with it? I think itll work out, just wanted to get a second opinion. I know yall have...
nah, the green one was a parts jeep. Got both axles, tranny/xfer case, roll bar and a couple bad seats for 300$ Snagged some parts off the...
resistance is way off. Stock is 73/23/10 sunpro is 240/130/33
My gas tank is leaking a little bit, and i have a replacement tank to go in it. I also have a sunpro fuel gauge and sending unit. Problem i see...
Pictures from the ad i bought it off of. [IMG] [IMG] [IMG] as it sits today after a new windshield, changing out the roll bars, adding a new...
I found i could not fit in the seat, so i did a wheelhouse notch. before [IMG] middle [IMG] after [IMG] after i get the power...
The original wiring where the PO and years of neglect had torn everything up [IMG] after i redid it. [IMG] [IMG] still need to clean it up...
Finally gonna put up some pictures of the work i have done on this here jeep No particular order, ill probably miss some stuff and might do some...
:oops: my bad
on my springs Its not a rivet, its a bolt that goes all the way through all the springs. Its under a decent amount of pressure from compressing...
Separate names with a comma.