My transfer case is hurting. I’m in the process of putting in a 4.3 sm465 and Dana 300 in the wife’s ride. Question is are the transfer cases the...
I am adapting a 300 to an sm465 with an input gear in the case anybody got a pdf of how to to take the case apart to do so?
The bearing in the warn hub where the splined gear rides in the hub housing is wasted in both of my locking hubs. The part is nla. any one found...
I have done the tracker conversion on the front . I plan on adapting the same brackets and using tracker parts on the rear. currently the brakes...
the boys 70 with a delco distributor just lost the roll pin to the drive gear. the gear shows some wear is there supposed to be a gasket between...
started tearing the donor down today [IMG] [IMG] [IMG] [IMG] only found one unidentified piece [IMG] thought it may have been mechanics wire...
managed to suck the remote for my 8274 out of my hand under the tire and into the mud,in doing so ripped the wires out of the hand control. the...
total cost less than three dollars.[IMG]just cut the lip off like this, [IMG] and screw it in[IMG] the wife likes that its white inside i like...
[IMG] just finished up waiting on header gaskets ,i think free shipping means pony express.
Looking for a picture of the carb end of the choke cable. The boy cant recall taking it off. A pic showing the bracket would be great thanks
I know ive got one somewhere but cant find it any one got one? had a nice color one i think i got here but cant seem to locate it on the...
Switched to swinging pedals on the boys 70 originally had a cable linkage and a short release arm. Want to go hydralic will the factory arm work...
The yoke on the 30 is larger than the one on the 27 I would like to run one size ujoints. Are all the front shafts the same? Can I swap a yoke on...
having a little trouble finding the stock length. seems like some say 7.8 some 7.95 would like to get some new ones. 73 304.any ideas? on a side...
Tried a search with no luck. Are the frame side mounts the same between a 304 and a 258? I know they share the same bellhousing pattern just...
bought a 70 to flip,the boy decided to keep it so the fun begins...[IMG][IMG][IMG][IMG][IMG][IMG]
finally got around to making the hard doors to go with the hard top. all the metal fab is done now just gotta finish em and figure out some...
the rear d44 on my 74 (stock) has a 30 spline end correct? looking at some upgrade parts and want to get the right parts without ripping it apart...
just got a new clutch kit and it has a bushing and a bearing for the pilot,any advantage to one vs the other never used a bearing type...
the part #23 in this pic( i have a non electric version pic is represenative...) should there be some kind of seal there i pulled a shredded o...
Separate names with a comma.