Thanks, I figured it was. That wiring harness was new but I got it in trade some years back. Was sketchy as hell, had missing circuits, dead...
I disconnected the S wire, jumped the terminals got the same result. Just keeps on cranking until the battery terminal is pulled..
So, I have a new/rebuilt starter from Delco, and a new wiring harness. So everything is new. Problem is when I turn the key to start the...
Wow, thanks!! I scrolled through that earlier and totally missed this link...
I'm in the process of wiring up my 70 and I have disassembled the turn signal switch with the hopes of cleaning it up and saving it. I'm guessing...
My drag link still runs pretty close to the pipe but I can live with it. Still finageling the rest of the exhaust into place but hopefully I...
I've found that when dealing with British bikes thebbest thing to do is just rip out all the original wiring and start from scratch. Saves a...
I get that, Fireball may or may not be running his backwards with no ill effects. Could be the FSM is wrong ( wouldn't be the first time). I...
That's the plan, I don't see that it matters which way it's on the springs are going to do their job regardless.
That's where I'm getting confused, the way Fireball said appears to be right but when I put it in that way the cups and springs won't go the way...
OK now I'm confusing myself. In this picture the left side goes to the front and the spring is on the rod side? [ATTACH]
I'm pretty impressed that you were able to narrow down that squeak. =) I'm usually chasing thumps, bumps and bangs.
I don't think I've ever driven a Jeep that didn't have a little bit of a gear "growl" when coasting. I worked at an AMC dealership in the 80s...
They could have been accidentally swapped
Didn't seem to be a whole lot of adjustment possible when bolting up the the manifolds. I actually don't like how it lined up with the front...
I just put in a new Crown master cylinder a couple weeks ago, it was the same. Everything was identical with the one I took off except the...
I like the two pieces going into the Y pipe better than the 1 piece from Waldrons. I had to put my old body into positions that it did not like...
I think that's it. Thanks Fireball. I will swap that around once my garage cools down a bit tonight and see how it works out.
I have a new exhaust system from Waldrons. After getting it bolted up, the tie rod from the steering box to the bell crank is rubbing on it....
That's what I'm worried about. I'm toying with the idea of getting a thrust plate and milling a few thousandths off the perimeter of the...
Separate names with a comma.