I inherited a Bestop top with my CJ-5 from the previous owner. The other day, I decided to see if I could put it together -- no instructions, so...
OK. I know most of you know the issues I have been having with brakes. I got new springs and installed them, bled the brakes and drove the Jeep...
I finally got the correct brake shoes for my Jeep and put them on. The part number on the box was exactly the same as the ones I was sent...
I just tried to replace the brake shoes in my CJ5 and I have issues that I didn't have with the old shoes. They look identical when compared to...
[ATTACH] I have installed a Saginaw steering gear as you can see in the pix above, which was taken early on in the restoration/modification...
I've seen a Bronco II for sale on the side of the road. It has been there a couple of days. Not knowing Fords too well, and not knowing the age...
I am assuming that Dana made several different types of differentials over the years. I have either a locker or a limited slip type 44 on the...
Today, I decided that my timing could not possibly be correct. I figured the F 134 that I had built and put the 2-bbl Weber on, had to have more...
Took my Jeep down the road today with tags on it for the first time. Since my wife has had to put up with my working on it and being a jeep widow...
The clip that holds the leaves in alignment in one of my rear springs has broken and fell off. They look to have been installed by crimping or...
So, today, I finished plumbing in the gas tank, took the Jeep down off the jacks and put it under its own power, but only in and out of the...
Today I finished putting my brake system together. The piping to the master cylinder isn't pretty, but I will clean it up later. As most of you...
Earlier I posted in here that I was having a problem with backfiring on my '62 CJ-5 with an F-134 engine. I had installed a Weber K-533 2-bbl...
Just the other day, while running my Jeep, I noticed that when I got the engine speed up to around 2500 rpm, it would start running funny and...
As I told you all before, I just replaced my stock ignition system in my '62 CJ-5. I used a Pertronix Flamethrower coil and an electronic...
As you all know, I bought a new distributor for my Jeep, but I can't seem to get the old one out. I am sure it is the original and has probably...
I meant to post this when I did it, but FYI, the recesses on the shift rods on the D-18 are deep enough you can actually install two seals each...
Does anyone in here have a T-98 with the same stamp as the one on my T-98? [IMG] I can't even find the simplest of parts for this...
I know that owning a Jeep, someone in here has had to find a supplier for just about everything weird. I need a supplier or a link or whatever...
What is this? [IMG] I have no heater in the CJ-5, but this piece attaches to the hose that goes to the windshield defrosters. I have...
Separate names with a comma.