Lock and key type cap.
This is the neck I used http://www.quadratec.com/products/51308_02.htm
http://www.quadratec.com/products/51308_00.htm this is the hose I used
The 76 filler worked perfect for my 73 stock tank. Just cut off the 2 nipples slip larger portion of neck into stock fill hose and tighten with a...
Has anyone ever used these seat brackets? I am going to make my own but I cannot find the dimensions for these. If you have a set please measue...
Yeah, I have almost looked through it page by page and the diagrams are crisp. I have also realized that there are 3 sections to the book. Section...
A customer gave me this Monday morning. It is Awesome! I do not know how old it is or if it is rare, but I love it. The manual seems to be an...
Perfect! That was the answer I was looking for. I tried a couple of different sockets and all seemed to slip I will purchase one today and grind...
Yeah thanks for the picture. I can see the fitting on mine and it looks just like that however, I cannot get anything on it. Any ideas? I tried a...
Thanks! That diagram helped a lot I think mine seems to be hooked correctly and both it and the hose are new. I will get a compression test done...
I have a pcv valve installed but it does not connect to the oil cap? The oil pressure gauge does have a new sender so I think it almost has to be...
I finally got my jeep running and drove it for the first time in 2 yrs, and only those of you who have reached that stage will understand my...
I feel like an idiot! The no turn signal when lights on was because I had them wired wrong. My signals have a 2 fillament bulb and one is brighter...
Thanks tim i think the ground is probably my problem. That has been the biggest challenge with wiring so far.
Nobody?? Must be something seriously wrong!
I have a few minor questions. First, have a 73 CJ5 with EZ Wire Harness and Everlasting Turn Signal (3 pin flasher). 1. I have turn signals and...
eric, clear email so I can respond. ;)
It was my selenoid. I tapped it with a screw driver and it seems fine. Now i juzt have to figure out the oil pressure gauge and turn signal. The...
Yes the wiring on the dash as well as remainder of the rest of jeep is brand new. The gauge is a 3 wire. I installed new head light switch, wiper...
That is correct. Then engine never started, it was just turning over. I did not want it to start I was just testing my wiring to see if the...
Separate names with a comma.