The lower steering tube bushing really consists of two parts: an outer steel bushing, with an inner plastic bushing that is pressed into the steel...
I'm gonna take out the shift tower this weekend and see what's up. I think that's where my problem lies too. I did explain my theory to the...
If it pops, it is always out of 1st gear, and always during acceleration - not necessarily hard acceleration either. I just thought it might have...
I have had the same problem. '75 CJ5 w/t-15 tranny. I had the tranny rebuilt, but they didn't do anything with the shifter. It doesn't happen...
I just got finished with a '75 power steering conversion myself. My two cents: Like the others have said, any AMC or Chrysler Jeep vehicle...
If you have the original indicator lights, you can buy the aftermarket replacements and just swap out the plastic rear portion that contains the...
Metric is much more likely than 3/8-18 threads. Why didn't I think of that??? Thanks HeavyIron! Off to the junkyards I go.
Great. At least I'm not the only one...do you remember what year the Caprice was?
I'm doing a power steering conversion on my '75 CJ5 and, so far, I've run into one problem: I bought a used pump, from an unknown year Wagoneer,...
I've got a set of 'generic' headers from JC Whitney. They are pretty poor quality, thin 1/8" mounting flange, really thin cheap steel tubes, and...
No problems with the installation kit. The picture of the kit that you will find online is not representative of the actual parts included in the...
P.S. if anyone is looking for a 3-spoke racing wheel, I've got one that I'm willing to part with - $10 plus shipping cost.
Definitely an aftermarket hub of some sort. I've just gone through the replacement steering wheel fiasco with my '75 cj5 (same column and all as...
I'd have to agree with rusty's last comment somewhat. I installed this same kit from Painless on my '75 cj5 and there were more than a few...
Here's a link to a thread I posted in the builds & fabrications forumn:...
Regarding your picture, you have something there with the hose connected to it that appears to be some sort of shut-off valve. Can you explain...
Anyone have any good sources for aftermarket bumpers that will fit the '75 CJ5? Only one I've found is Hanson Products, and they're waaaay too...
If you can wait until tomorrow, I can snap a picture and add it to the post. Too dark right now.
It would be the same style connector that attaches to the back-up light switch on your transmission. Not a big deal if you can't get hold of one...
Sounds like you work for Tuffy. How about making some products for the 72-75 CJ's :)
Separate names with a comma.