My dad has a 71' CJ5 with a 225 v6. While taking it apart he noticed the lobe for the fuel pump was worn and had grooves in it. Will the crank...
After cleaning and sealing my 1961 cj5 gas tank. Which is the correct threaded hole on the bottom to hook up gas line? One is level with floor...
Contact Brian Hainer on facebook, AKA Metalshaper. He sells the correct lubricant for Ross Steering boxes and front knuckles as well as t90 and...
After taking upholstery off, my seat frame was rusted through in many places and broken in two places. Not restoreable. Can a later model CJ5...
Has anyone mounted after market seat Rugged Ridge or other brand seats in or on early CJ5 frames with the built in tubing back frame? Mine are in...
I forgot to take pictures of the heater hose route on 61’ CJ5 with a f134 when disassembling engine and removing from chassis. Does anyone have...
The brass Y fitting on the front of the master cylinder is the only one any one sells. Orient it correctly for one of the holes and plug the...
Has anyone had to replace the studs in a the turn signals on the front grill of an early CJ 5? Nuts froze and studs broke off of mounting plate.
I don't know what this material is called, it was used on new cj5's between the top of the radiator and the back side of grill. It was purpose...
Novak probably has the correct ones and will know the size.
What is everyone using as the rubber washer that goes under the nut and flat washer that holds their F-head valve cover on. Mine was falling...
Measured the end of my Pilot shaft and it was right at 5/8". Cleaned bushing with a 5/8" reamer and test fitted flywheel and no slop and fit...
Put sealant on the spines of the yolk as well. I just finished my D-18 / T-90 rebuild. Just pried my seals out . Once while in the jeep and...
What is the proper clearance of the pilot bushing in the center of the flywheel, between it and the end of the pilot shaft of the transmission?...
I need to replace the rear bumper/cross member on my 1961 CJ5. I got a new one with rivits. Has anyone just bolted the new cross member on or...
Head may be warped, It needs to be machined and leveled along with the top of block if possible, in order to have two good mating surfaces.
Thanks for all the suggestions!!
I am replacing my dash on my 1961 CJ-5 and am curious about what type of bolts people are using and how they are keeping the paint from getting...
ground the notch and it worked fine
I recently bought a new lower cluster gear for the T-90 transmission I am rebuilding. After receiving the new cluster gear I noticed that there...
Separate names with a comma.