I broke a rocker and ordered a new one, do I have to have the keeper pulled off and pressed back on to replace it, and is this something I can do...
Anyone know if the top hole that attaches to the rear crossmemeber is threaded, if so what size is it? I can't see it the tub is on :oops:
I am trying to get the CJ road worthy, started it up today and cylinder #3 is not firing. This has been an issue for a long time and I have just...
Will a 76 windshield frame fit a 62 cj5?
Should I figure out what year windshield I am using before I pick a top for my CJ5 fiberglass body?
I am about ready to mount my roll bar to a fiberglass body, does anyone have the exact mounting location. I would hate to locate it wrong and have...
Hey guys what kind of hubs are these, in case I need parts:
Anybody have a pic of a tranny boot and boot ring installed, I have just painted mine and ready to install but the boot ring looks too big.
I have tried searching for this with no results, does anybody know what would cause a hot coil and should I replace it. Thanks for the help it is...
I am sick and tired of replacing Bendix gears in my starter. I usually pay the starter shop to do it, this time I think I am going to do it my...
I am finishing up on my tail lights and I can't figure why the turn signal wires , both of them are hot even when not activated. I go to hook up...
I think my water pump is going out. Every time I start it up something screaches for about 30 sec. and then goes away...then the engine smooths...
Will my tail lights work if the fronts are not hooked up?:?
Is there a way to prime the fuel pump. I can get the engine running with starter fluid, but it won't stay running. I removed the pump and cleaned...
Hey guys I disconnected my negative battery cable when I replaced the tub but can't for the life of me remember where it hooks up...brain fart....
Does any body know the correct route of the hand brake cable in the engine compartment; behind the exahust in front of exhaust? I have it...
Any one know where to get a gasket for the air horn...is it rubber or paper? F-head
I have started to clean up the frame now that I have the body off. I am using a 4 1/2 inch grinder with a wire cone shaped brush. It seems to be...
http://www.autometer.com/cat_gaugedetail.aspx?ref=search&gid=2646 Will this work in an early CJ-5, cable size, is 5" too small for the oem dash?...
If I jack up the rearend and I turn one wheel forward the other one goes backward...does this mean I have a posi rearend or a locker? Its a Dana...
Separate names with a comma.