Do you have 1157 bulbs? Silly things I over look all the time.
I had similar issues with mine when I first got it running. Not as bad as yours seems. Originally rebuilt the carburetor with a generic kit....
Well I asked around and this is what I was told. You should not put a fuel filter before the pump. There is always a small amount of air trapped...
I have a '61 CJ-5 rebuilt to mostly original specs. Rebuilt 134 engine, rebuilt carburetor, and a rebuilt fuel pump. A few weeks ago I took the...
I come up with 25 9/16"
I did this my frame. Here's a link http://www.earlycj5.net/forums/showthread.php?93489-Electrolysis&highlight=electrolysis post #21 has a link to...
If it"s going to be a daily driver and you don't care about a restoration job, fiberglass might be your best bet. Salt water, salt air, and salt...
I had to ground the sending unit to get mine working.
After four and a half years finally got it out of the garage. Still far from finished, but it started, drove down the road, and stopped. 2008...
Hello Kitty. Lookin' good. Is the tailgate area narrowed? I kinda like it tweaked in like that.
Couldn't get mine to start. After 30 minutes of head scratching someone suggested to check the firing order. Of course I had that right. Wrong....
here'd how I wired mine. [IMG] red wire went to battery positive to ballast resistor. yellow wire from ballast resistor to coil positive. light...
I'm in the process of mocking mine up now. I currently cut one inch blocks of wood to rest the body on the mounts. I want the body to sit as...
you might want to consider a large thick washer on the two bolts going through the hat channel. Something that will distribute the load out to...
I'm only about an hour from Walcks. Kind of embarassing, but I never knew they were that close. On the same token if i purchase from a Pa...
Most likely I'll be getting a new tub. Each time I pass the old tub the overwhelming amout of work pushes me in that direction. This project is...
Looks like you can get the tubing from McMaster-Carr. The flaring tools for 1/8" don't appear to do a double flare. Since it's a vacuum line it...
what is that used for. Mine goes from the pvc directly into the head/intake. No tee fitting. Where does the 1/8" tube go?
Thanks Sidscj, Didn't even notice the hole in the plug but I do now.
The 134 is set up totaly different. It has an elaborate system of rods and pivots, but I don't see where a return spring would fit into the mix.
Separate names with a comma.