I've never owned a Commando, and have been looking. Today I bought this '70. Needs some work, but I got a fair enough deal, and I don't mind doing...
Well, after all these years, I've never posted in the Jeepster Commando section:D . So, I understand that at some point they changed from Ross...
I sold the TJ today. It was a nice "Jeep", and I had a fair amount of money in it, but since I got the flatty, and then the Tux, I rarely drive...
Are the oil filter lines different between the L-head and F-head? Both with the C3 filter housing. My son's 59 needs a return line, so I figured...
So the flatty still has the issue of flooding after I shut it off when it's hot. At this point I've done a lot of things to try to cure it, but to...
Has anyone recently installed new front fenders from Crown/ Omix? If so, is the quality better than what I'm afraid it will be? I reworked the...
My Dad told me he put BDS springs on the Tux, but I seem to remember them being Black Diamond. Now, looking at pics and descriptions, they sure...
I'm hearing/ reading great stuff about Engo. Apparently one of the guys there used to work for Mile Marker. Looking at the E9000S with synthetic...
My dana 18 has a Terra-Low 3:15 gear set in it, and it was installed with whatever intermediate shaft they supplied at the time. It has 15-20K...
Does anyone know of a source for a single groove water pump pulley for the dauntless? Another application that will work?
What have you guys done for a steering box brace with Saginaw power? I realize every conversion isn't the same, just looking for ideas. I'm...
Anyone done this? So that the lid opens from the rear; hinged at the front? With the seats I'm fixin' to put in the Tux, it would be easier to...
So the my '67 has the factory 60/40 bench seat. My Dad had it re-upholstered, but they retained the original springs. The seat bottom is really...
Have any of you run an overdrive with an automatic transmission? More specifically, a Warn style on the D18? The Tux has a TH350, and 4.88 gears,...
Today I bought my Dad's 67 Tuxedo Park. V6, Offenhauser, Holley 390, MSD, Pertronix, Comp cam, TH350 auto, Tera Low 3.15 transfer case gears,...
So I'm getting ready to swap the original front 9" brakes for 10" brakes on my '48 2A. The Jeep has the "S" lines from the rubber brake hoses to...
So I rebuilt the carter on my son's '59 F head, but it was a remanufactured carb, and the throttle shaft is very worn, and the seat for the...
Is it possible to (successfully) remove and replace the timing cover without dropping the oil pan? I need to replace the front seal and hadn't...
If I'm careful, can I remove and replace the input shaft without removing the main shaft? I'm a bit worried about the input shaft bearing, and...
I've searched, and read, and I think I found the answer, but would like a more definite answer.... If I wanted to convert my "C" spring shackles...
Separate names with a comma.