R)
Well, I've been playing around with first dry and then greased up needle bearings and going back and forth between dropping them and not being...
Makes sense... I've since found this out in a manual. I had thought that the tab had something to do with the locking mechanism and based on the...
RockRunner85, thanks, good advice that. Now for a combo update... And there was another weekend. I needed to get into the barn yesterday and...
PS. the rear pinion isn't leaking. I was a bit shortsighted and realized that it would stop leaking when I torqued down the yoke! Just glad that...
Good news and bad. Took the old clutch throwout bearing off and easily installed the new in the vise and then realized that the rear pinion seal...
One of the first nice days of the year so the boys and I got outside to play and work on the Mistress. A few little things done. I installed the...
Sitting around the house on yet another below 40 degree early spring day and feeling anxious and I realized what was up... I needed to get my...
Hey, mine looked much worse than that four or five years ago when I first got her. Now she still is incomplete and not even running yet, but its a...
Yay, small steps! I finally got around to ordering the replacement pressure plate bolts from Walck's a couple of weeks ago. Got a UPS tracking...
Slow progress/ no progress... Forgot to post that last week I did get that broken bolt out. I bought an easy out set that seemed to have alot of...
So I also need to invest in something better than my little old tap and die set. Anyone have a recommendation for a good quality, preferably...
One step forward and two back today, man am I bummed... :( But first the good news- I spun the pilot bushing on the end of a taped up bit on my...
Didn't get much done today, still too damned humid to feel like moving. Tried tapping in the pilot bushing after taking it from the freezer......
Another scorcher today that really sapped my drive. Got a bit done though... Cleaned up the flywheel to look nice and purty with a bit more...
[img] I started getting alot of work done on the T90 today and one of the gems that I uncovered was the original casting date for the case......
A friend of mine on my forum suggested a 1/2" socket extension and I'll be damned if it didn't work perfectly. I tapped it a few times and moved...
Thanks, Stout. I'll work on the flywheel like that then. What are you using for a good degreaser? I have been using Simple Green and it works ok,...
So, been giving this alot of thought lately and here's roughly what I hope to accomplish this summer/fall. First off, the Mistress is sitting on...
Ok, I finally had the time to start with tearing into the T90 today and it came apart (mainly...) as slick and simple as butter... that is once I...
Separate names with a comma.