yea. Installed the regulator & guage. Currently running about 3.5 lbs. of pressure. Actually seems to be getting better. Just a lil more adjusting...
I put a "new to me" Weber carb on the 258 and seem to have it adjusted...kind-of. I bought this carb used so it didn't come with a manual or any...
Timgr. I thought you'd chime in. I was hoping anyway. You are probably correct & now I kind of feel like an idiot:oops:. I should have thought...
So I recently swapped out the 1 barrel Carter for a two barrel Weber. Got it installed & fired up. It seems to run fine w/ no sputter or backfire....
Cool idea. Add one more to the build list:smash
Ricardo77, If you plan on doing quite a bit of body work I would strongly recommend buying a D/A sander. I would also shy away from using the...
I just finished mine. still needs paint but it's some ideas for ya. [IMG] [IMG] [IMG] [IMG] [IMG]
I just installed a 2" susp lift on the CJ5 and still have a fairly bad lean on the rear driver side, about an inch to inch and a half. It was...
33s are a good idea. 35s will probably rub offroad and will be a little harder on your axles. If you don't mind doin some fender trimming 35s...
yea, all the x-tra nuts are a downfall. You need to check them more often. I used locktite on mine. Mine are also made from stainless, so I have...
I run 1 1/2" up front & 1 3/4 in the rear of my '78 w/ 32-11.5-15s. I like 'em. Keeps the tires clear of parts. I still rub my fenders a bit but I...
I found a couple of Carter 2 barrel carbs for a 258. They are only $5 each. Would these be good carbs to rebuild & use. I'm not sure which carb I...
Finally got the cage going. I still need to weld in my gussets & do a lower windshield bar but here's what I've got so far. I put a coat of primer...
Heres how I mounted mine. I just welded it up on Friday. [IMG] [IMG] [IMG]
check this out. I just ordered one (2") for my '78 CJ5. I believe it is made by Superlift. $450 shipped. Complete w/ springs, shocks, shock boots...
I Have 1 1/2" shackle lift. The caster angle was all out of whack. PM McGruff. He'll make you a set of 5* angle shims for $26 ( if I remember...
Unless you do alot of deep water riding, ie. rivers & such, I wouldn't bother. While a snorkle looks cool, if you ride alot of wooded trails the...
Thanks all. I've decided to go with the 2". Seems like the best choice for my application. The 5 will see plenty of off-road use but mainly road....
had the same deal with mine. Corrosion kills. A little cleaning goes a long way.:beer:
I am currently building a cage based on the "sport cage". I have already fabbed up the brackets that mount to the dash. They made me a little...
Separate names with a comma.