Pretty cool. Did they stop making those with the advent of the intermediates? Tim
I wonder if there is a problem with the sealing surface of the crank? Do you know if the engine was rebuilt before you got it. Could it be ground...
I purchased a Ford 460 from S&J a little less than a year ago. Customer service was very good as far as the purchase experience went, especially...
I run Truetracs both front and rear in my 95 F350 and am very happy with them. Living in Alaska, I lock my hubs in when the first snow falls and...
Is this close enough? I think that era used a lot of 56 series connectors....
Here is a good video I saw a few months ago on doing a similar repair to a T19, which would be the same for T18. [MEDIA] Tim
Technically I think where the hard line is connected to rubber line, the hard line has a “bead”. There are special tools to do that but from a...
It’s some stuff I bought off of Amazon called Uxcell heat and sound insulation. I just refurbished my hard top and am getting the Jeep prepped for...
I have a Meyers hard top. It is about 33.5” from the wheel well to the top, pic included. This is at both the B & C pillar locations. The back of...
I believe I sourced mine from Napa. Tim
3M strip caulk also. Tim
Are your u-joints centered in you knuckle, that should tell you whether you have the inners fully seated or not. Tim
Their chart looks a little off in reference to model year. I think what Velopa wants is what Dutchman lists as 69-70. I think I have a set of...
I had one of those on the passenger side when I redid my d27. I used a digital angle finder to compare the driver and passenger side when the axle...
My ‘69 is Avocado Mist, doesn’t look like that. I think Vintage Gold Metallic. Tim
There was also a piece of wood in the hat channel to help keep it from collapsing that has probably been removed. You might be able to fish a...
It is certainly not exclusive to Jeeps, Series Land Rovers and FJ40 Landcruisers also have the leaning issue, even my Triumph TR6 had a slight...
That’s one of the tough things with a 3 speed. If you’re about 45 in top gear at 1800 rpm with 3.54 gears, I’d guess you’re running something like...
Making sure the choke cable is not binding and well lubed is a big plus also. Tim
On my ‘69 cj5 the outlet to the heater is the port on the right rear of the intake and it returns to the nipple on the water pump inlet ( where...
Separate names with a comma.