V8 CJ power steering Came off a 79 CJ7 Will ship on your dime. $200 Located in central MN. [ATTACH] [ATTACH] [ATTACH]
OEM 72-75 CJ Roll Bar $50 Prefer pickup but will ship on your dime through Fastenal. I might have transport available late May to the south...
Power steering setup off a 72 V8 CJ5 with 4" drop pitman arm. Draglink will be removed as it is shot. Located in central MN. $200 I will ship on...
I'm assuming this is on the CJ era Dana 30's where the ball joint is in the outer "C" not the inner on the axle tube. You don't need to purchase a...
They have been cut out already and not by me, so I don't have any.
FYI, when you are shopping for your rope to go on an 8274 you do not need the high temp rated rope as there is no brake inside the drum creating...
I have a 70 Jeepster in the woods up north and I think the motor mounts towers are still in it but I won't be up there for a few weeks. I'll...
It has a 4V carb, could have a 401.
I saw that too, and thinking about it.
If you can't locate one local to you, I have one here in MN that I can get it to EJS or the Denver area if that helps.
Not mine, but less than 20 miles from me. Marketplace - Buick Fireball V6 225 3.7 Jeep Dauntless and ST300 Super Turbine 300 2 speed automatic |...
Same Jeep with 31x10.5 & 33x12.5 both on 10" wide rims with 3.5" of backspacing and a 25-year-old sagged out Rancho 4". The 33x12.5 rubbed a lot...
I was doing the math thing also. I have a few yokes here already, need one for the front too and at least a dozen core driveshafts to use for the...
Yes, I have a centered 44. There will be no "comp cutting" of the body to get this done if I decide to venture down this path. I do have the...
Yep, read all that. Just wondering if anyone here has done this. I'm not too concerned with altering where things are located as I done that...
Tell me what you think. I have a line on a Dodge 4wd NV4500 with an AA Atlas/Dana300 adapter on it. It does have a stock 29 spline output shaft in...
I don't have a need for these at the moment, but I couldn't pass them up. I will be swapping them onto different rims when they I find a home for...
This is what you get when you put a 101" wheelbase body on a 94" wheelbase frame.
I'm not looking for a set, I've just have always tossed them when parting out post 75 CJ"s which I have 2 now to part. Just looking to see if...
Does a complete 11" AMC 20 drum assembly swap onto a CJ Dana 44, backer plate and all? Has anyone ventured down this path?
Separate names with a comma.