I use a pump similar to this one. Mine is John Deere branded, but otherwise the same:...
I turned a little at a time off the bolts and tried them in the reamed holes until they were a very light tap fit. Turned between centers so they...
This is what I did. Two and a half years later it is still running well. Smooth, quiet, and stays in gear.
I had this exact situation. Transmission was noisy and jumped out of gear. Aligned everything and rebuilt transmission and it is smooth, quiet,...
Interesting thought. After reading your post I bent my OD lever slightly more leftward. (Used hydraulic press instead of heat so I wouldn't have...
Actually, I will be wiring it up in the next few days. Added the switch while I had the transmission top exposed for the overdrive project. I...
Here is how I ended up. Heated and bent the OD lever and both TC levers with acetylene torch. Sandblasted and powder coated them. The 2 TC...
Looks like your 4WD lever also bends opposite mine. I guess heat and bend will be the solution. Thanks for the posts.
I tried it the other way - it still interferes.
I got the shift linkage from Herm for a front-shift Warn overdrive I rebuilt. The OD shift lever interferes with the front wheel drive lever as...
I brazed mine. Sandblasted the area first and washed in solvent. If doing it again, I would also braze a fender washer or similar piece of steel...
Thanks for the replies. I went ahead and reamed the holes to 7/16". Drilled 25/64, 13/32, 27/64, then the reamer. Made some tight-fitting...
Rebuilding my T90 and D18. The flywheel pilot bushing bore was badly worn egg-shaped. So I checked the concentricity of the bell housing bore...
I'm planning to use sealant because the surfaces of the bottom pan and the end cap are not perfectly flat. The milling of the case casting looks...
This article shows the felt seal going just inside the yoke: D-18 Transfer Case Assembly - This-Old-Jeep.com I used assembly lube on the shifting...
A friend is putting disks on his '70 CJ5, and offered me the 10" brakes he is taking off. My '63 CJ5 has 9" brakes. Would it be a direct bolt-on...
Here is where someone else had the same problem: Looking For Pics Of Tcase Rear Bearing Cap Boss For Lever Stud I have the same problem with the...
Thought I would post this if it might help avoid an accident. Was approaching a stop sign with my 1963 CJ5 a few days ago and the brake pedal...
Here is how I did it: [IMG] http://www.pbase.com/mikeon/image/161464409/medium
The Solex on my F134 has a similar issue. As a test, I started the engine cold and let it run only about 15 seconds to fill the carb bowl, then...
Separate names with a comma.