Thank you for sharing this! What length Speedway column did you use? What is the length of your adapter?
Dumb question: How much does the rear axle swing to the rear on spring compression if it's fixed on the front mount? Just the length of the shackle?
Warloch- What are the dimensions of your tank? Do you set them up to pull fuel from the bottom or through a sending unit out the top? Do you have...
tarry99: The last picture you posted is really helpful - thank you. Did you reuse your captive nuts on the backside of your floor board or did you...
Is the lower steering column mount at the floor considered highly structural or just to simply support the column from excessive movement? I have...
Thank you. Before I posted my question I did a search and the thread you referenced was one of the many threads I read with "Toyota starter" as...
Is the plate between the engine and bellhousing the same for a L134 and a F134?
Thanks for your replies. The reason I was asking is because my buddy has a M38 with a Chevy 283. Those removable floor panels and flip out...
Was the M38 the only flatfender to have the large removable floor panels around the transmission hump and firewall? -Thanks-
Is column length measured from the floorboard or entire end-to-end length?
Thanks - Yes, there is a Santa Claus!
I was only going to ask you if you got bored! :) -Seriously, thanks for the responses and the web links-
My memory is foggy, but I seem to recall about 5-10-15 years ago JP Magazine had an article about installing fuel injection on a L134. It wasn't a...
I hope you're not working under your jeep while using the cinder blocks to support the jack stands? I want to see you complete this thread...
Thanks for all your replies... and so quickly! :cheers:
I know this should be in the Flatfender forum, but this section gets more views obviously. Is it possible to run the Dana 18 without the...
I just started doing this swap this weekend. So far I've got the NP435 torn down and its OEM mainshaft swapped with the Novak mainshaft. Things...
Do you happen to have pictures and dimensions of the T98 crossmember set-up?
Thanks for the pictures - 7.00 x 16 tires it is! I am replacing my grandma white spoke rims with stock rims from a Willys pickup. This morning...
Are they the tires shown in your avatar? If so, I'm sold!
Separate names with a comma.