So I've had a couple people PM with interest in these, but I have no idea of their value. I don't necessarily want to give them away, but I don't...
Yes.
The guy I got them from had them in his garage but had a roof leak during Sandy but thought they stayed dry. Right now the 44 is inside and the 30...
Do the above measurements make sense, and help identify the axles?
Finally got a chance to do some measuring. D44: 45 5/8" flange to flange. 27 1/4" perch to perch. D30: 40 1/2" castle nut to castle nut . 27...
Neither axle has the actual axle shafts installed, so where would I measure from that would give the "right" measurement?
Anybody have any need for parts from these before I either scrap them or put them on Craigslist? Not too sure if there is anything good here.
Opened up the D30 and this is what I found: [IMG] ( I don't know why this photo is not as big as the other. . .) Ring gear has 41-9 on it. [IMG]...
When the monsoon subsides later I'll give that D30 a better look. Now to do a little web research on what a Detroit locker looks like. Would there...
Well, it never came with a cover... Not sure which set of numbers to divide? [IMG]
Folks: I picked up these axles on a parts acquisition run. Front is a D 30 set up for disc brakes. The rear has me puzzled though. I think it a...
Peter DeBella has some, but they're pretty spendy: http://www.debellajeepparts.com/index.htm
Sweet!
And the work continues: Over the past couple of weeks I stripped off the tub, etc. from the '69. Yesterday afternoon I pulled the V6 and got it...
Thanks! I looked at those flat stock bases on mine again last night, and they "might" have been modified. The are 3/16" stock though. One thing...
Cap-n-Cray, Can you measure up your angle for me as well? The flat stock on mine has a different hole pattern.
Thanks!
Picked up the roll bar yesterday evening and scored a drawbar hitch in the process, so it was definitely worth the trip. Could somebody measure...
Thanks for all the input guys. It was hard to tell from the Whitco literature on the web if their bases were angle or just flat stock. My ID was...
In the email exchange I've had with the guy, he stated that it came out of an early CJ5.
Separate names with a comma.