Bump for pics. After getting a new brake pedal arm, I can't get my pushrod to link up between the dual mc and the arm. What's the trick?
I've taken the intake off and looked for crack. Couldn't find any. The rectangle gasket between the intake and exhaust had a crack, but it...
The carb still has the same setting it came with. The float bowl and need valve were cleaned recently as it was sticking open and flooding. I...
48 cj2a, L head motor. The engine was rebuilt, plenty of oil pressure. No leaks except the rear main. 12 volt conversion with gm alternator....
Stock type bearing. I honestly don't remember seeing a felt seal in the gasket kit. That must be it.
My transmission is leaking and I'm having trouble figuring out where the problem is. I rebuilt the transmission with a couple new gear, synchros,...
Quick question for everyone running an L or F head engine. What brand oil are you running? What weight? Is the rear main leaking?(not weeping)
A friend of my broke his dana 18 once. I had a 20 case, upgraded rear output shaft and a lower gear set(not sure if it was terra). It was behind...
The center hub on the clutch disk is offset making it impossible to assemble the disk backwards. It might be possible to put the throw out...
I was all ready to go for a first drive today when I discovered that the clutch will not release. Everything is new, so it may not be setup...
I've got the kit too. It's for the cj-5. It doesn't fit the cj2a a L-head motor. The bellhousing/engine is in the way. Here's how to make it...
This just isn't working out well. I got a new head, new gasket, and it's leaking water again, but at the head gasket this time. I checked all...
I've got two spare heads already. I'm just hoping to avoid whatever caused that crack. The next head I'm going to try has ribs between the...
The head cracked on my L motor. I haven't even started it yet. I had just put water in the radiator to check for leaks, and it turned out the...
I'm helping a friend setup a gm tbi on a stroked 350. Probably the best two things you can do is get a set of balanced injectors and add a fuel...
My pile-o-jeeps came with two heaters. They are obviously not stock, but they do look pretty old. The id plates are unreadable. Should I...
A turbo 350 is a couple inches shorter than the 700-r4. Because the oil pans on those trannys stick out to the passenger side, the xcase has to...
Awsome pics. A wingnut on the foot looks like the best option for my setup. Thanks.
How does the passenger seat bracket mount? From what I can tell, the front legs are in pivots and the back leg just sits on the floor. It seems...
You guys are awesome, and correct. After counting the teeth six times(because everything is put together), it turns out to be 124 teeth, the 3a...
Separate names with a comma.