Got a great deal on an overdrive...can you all look at the pic and tell me what I'm missing... [IMG] Other than a new gasket and knob...copper...
was cleaning up a t90 spare..noticed the retaining plate between the reverse idler shaft and and lower rod wasn't there..the lower rod shaft is...
going to be ordering the 1" superlift for my 2a. I also have a set of new "H" shackles I got from a member here. Question I have is what to do...
was at the pick a part today and they had a 63 falcon. It had a 144 straight 6 and the ford (autolite) carb on it. Numbers are C3DF B which I...
called napa and autozone...no one could find this.. http://walcks4wd.com/grease-retainer-outer-rear-axl.html couldnt cross ref that number...
so my willys has always been hard starting from a slumber (vac gauge showed engine was good/normal)...had the ys carb on it and i hated the vac...
can someone please tell me where i can get a replacement banjo fitting for the solex..i cant find one anywhere!!
even though my t90 is in a 2a..i know this forum gets more traffic..anyway.trans felt super lubed/greased up when shifting...put trans in neutral...
i posted a thread in the flatty section, but i figure this section would know for sure... the distributor in my l134 looks identical to the...
ok..so I have a full set (5) of stock 16" rims for my cj2a...I also have a full set of 15" rims from an old cj5.....so...I know asthetically there...
can someone give me the dimensions for the hub dash decal....thanks
since there is a wealth of first hand knowledge here..i am researching the pros/cons/opinions of each of the carbs that came on the 134's... so...
so i was bored today after i got all my chores done....did my once a month check on the fhead in the cj5 future project...since i got it several...
guys on the g trying to figure it out and has me curious... http://www.g503.com/forums/viewtopic.php?f=66&t=171564&p=988558#p988558
stumbled onto this site..liked the spen trailer ad... http://www.flatriver.net/ctlg/WillysSpEqu/index_2.htm
so im going to start rebuilding my hat channels tomorrow....quick question since mine dont exist...lets see if i can explain it...under the door...
:roll::roll:so i started putting the new lines on the cj this a.m.,,,,but i have a big issue...wheel cylinders brand new for a 75 cj-5...
so my master cylinder is enroute so i figured i'd test the old one...i want to drill/tap it for a remote reservoir..first i thought about the...
next step on the cj is to do the steering system..my one piece tie rod is enroute,and the box assembly has been sitting out..going to order all...
so i was reading the warn hub decal thread..and was wondering if the selectro,sears,etc hubs had a decal also...anyone?
Separate names with a comma.