Hey, anyone have a Good product for coating the shop floor? Good or bad experiences. years ago I coated my new shop floors with a Muralo two...
Well folks After close to 35 years, my old Emglo Compressor is ready to be retired. It still runs and works but takes to long to build air and...
Trying to get my Dad's 67 running again. cranked for a bit, then stopped. just got a loud click click so figured starter was bad. Son put a new...
. Anyone else have this issue..I was just thinking about all the tools I've acquired over the years and use regularly as I was reading threads....
I'm looking for a list of all the parts that are T-98 4 speed specific that I should pull off a possible donor. Obviously transmission and I think...
Are setup bearings the same for the regular and flanged 44? Anyone have a set I could borrow? I am re gearing my Flanged 44 and adding a...
My dad dropped off his 67 this weekend because it wont start. Ive worked on it most of the afternoon and cant get it to run. Stock v6, Pertronic...
For years I've struggled with my Holley 390 carb. From new it's always had a hiccup / hesitation when I step on it. I've had diff carb shops...
I have a sm420 with adapter and v6 bell housing sitting in the shop, I'd like to swap it into my dads stock 67 with a v6 and a T14 as his clutch...
Here's the Story of my great Score on a 8274 and the way I went about mounting it on my CJ3B. Story: I went to get an air compressor from a buddy...
Figured I'd start a build thred. Here's my '65 CJ5, It's in amazing condition, almost no rot threw at all! original floors, hat channels, etc. no...
I've rebuilt: Transmission (I sealed cluster gear shaft at front. used sealent on any bolt going into tranny, oiled my seals etc.) Transfercase...
Hello all. I'm rebuilding my my t-90 and spicer 18, when I split the two the rear tranny bearing and a beveled washer fell out. My problem is I...
When where the Power-locs first offered as an option? Where they an option for the CJ2A's 3B's and 3A's or did it start with the early CJ5's? I...
First off I have to say thanks to Ivan the PO of this "Farm Jeep" for giving me the opportunity to preserve this piece of history. Anyhow I...
I love surprises!:evil: Went to check the bearings in the axle I just swapped in. I'm down to the last wheel everything else is done on the axle...
I swapped in new stock springs under my '48 2a yesterday and my while hooking up the rear drive shaft I noticed that the joint is binding up at...
I need a picture of the original soft top doors on a early cj5.
Do I add a little permetex form-a-seal between each one or just install them dry? Nothing was on them and I'm worried about throwing the pre-load...
Running 2.5" lift, and it looks like my rear brake hose is going to be a little short? Does anyone know where I can get one that's around 20"...
Separate names with a comma.