Hello, just to ask what else we have except the original Carter and the crappy chinese solex that we can fit on the f-head?something that someone...
another one fast question, i tried to timing my engine with the timing light.The marks are on the engine side good.But on the pulley they are a...
Hello! Just to ask quick whats the correct orientation for the clutch control tube.There is two levers.One "big" and one "small".which one goes to...
Hello, after 2 years jeep sitting i was tried to start it again.As you guess the engine f-134 is stuck,tried all combinations with thin...
Hello, I own a M38A1.Please can you tell me the length of the shocks front and rear from hole to hole open and closed? Mine was 27cm closed and...
Hello, i have a m38a1.I want to ask what axle type it have.Tappered or flanged? And what's the difference between them? Thank you George
Hello, please can you tell me where can i found complete disk brake conversion kits for the front of M38a1? Can i use one chamber MC or i have...
Hello again, Just bought one Crown automitive gasket for the f-head that is blue on color.I have never use this gasket again.comments? And are...
Hello, after three head gasket changes new head bolts seal in the bolts and master how to torque the bolts i have the same failure. the engine...
Hello, please can you tell me what size of diameter i have to order for the bellcrank for the m38a1? And is there any secrets on the...
Hello, please can you tell me whats the part number for felpro headgasket for f-head and can you supply me with some dealers to ask them if they...
hello, my engine is running rich.grey smoke from the exhaust.and smells semi-burned gasoline. solex carb,points new,plugs new,condeser new,fuel...
hello, i have just purchased one electronic distributor.Very simple installation but have one big problem.the engine don;t start.after cranking a...
hello, does anyone know whats the correct amount % emissioned from a well tuned f-head?? thanks
can anyone tell me why the military engines have washers to the head bolts and the civilian not???? thank you George
hello, just purchased from mistake one 735994 fuel pump for my f-head.is it some way to fit it to the f-head?have someone try it? thanks George
hello, what size reamer i need for the exhaust valve guides of f-head? thanks George
hello, i want to ask whats the length of the threads opened in the block for the head bolts. i want to fit some 4-1/2" grade 8 bolts that i...
hello, is the rear and front shock absorbers the same type (length) on the early cj5???? thanks George
helli, i just bought one silverline 1/2" torque wrench (No.633567) http://www.silverlinetools.com/index.html?code=633567 i know that is the...
Separate names with a comma.