Hey all I figured you guys might get a kick out of this.. I told my buddy he could have this old 62 CJ5 that has been sitting in the woods for...
Hey everyone, I'm looking for a rear main seal for a CJ5 with the Perkins diesel. Does anyone have any good parts sources on these motors?...
Hey could anyone tell me what color a L6-226 would've been painted originally in a '62 Truck? I've seen them in everything from black to red.....
hey could someone refresh me here, i've got a '73 CJ5 with a worn mainshaft in the trans. i can't remember which trans they put in these...
can someone tell me the difference between a 473 CJ5 and a 475 CJ5? They're both powered by an f-head/t90 combo? I know a 463 is the L-head...
hey everyone, i'm curious what years did they put the offset flanged dana 44 rears under CJ-5s? thanks, evan
so i installed my new 12v sending unit and fuel gauge and it seems to only partially work. most of the time it jumps to full or it will jump...
Hey everyone, I'm trying to remember which terminals are which on my 12v generator that I'm putting back in my 2A. It has one terminal in...
alright, so i've got this starter for my '48 cj-2a. it worked perfectly about 6 months ago when i was driving the jeep around. i recently...
alright so i've deduced that i can swap the entire starter drive assembly over from an f-head starter to an earlier l-head starter. my question...
hey everyone. i've got an f-head starter and an earlier l-head starter. the bendix drive (ratcheting part) is worn out on my l-head starter. does...
i know there's a 3.15:1 kit for the d18, but i remember reading somewhere that someone had produced a kit that reduces the gearing even lower. has...
i need to get a dipstick for my '42 GPW L-head. I have a dipstick and tube off of an early F-head, does anyone know if it should be the right...
Alright, here we go again down the road of which oil to use and whatnot... Basically I've just finished building my flathead and have been...
hey everyone, i've pulled many a head off a motor and have never seen this before. i'm working on a '72 CJ5 with the 304. I've got all 12 head...
I know the Novak kit for the Spicer 18 is almost a must due to their hardened intermediate shaft. What about a rebuild kit for a T90? Will one...
hey everyone, i need to get a waterpump for my L-head. a new water pump is around $50. I have a pile of old waterpumps for l-heads. I was...
I've read about it before, but I can't remember where.. Anyways, I think it's possible to install a Centerforce Dual-Friction clutch behind an...
i've heard it before, but I can't remember: can someone explain to me how NDTs are sized? I'm trying to find an NDT that's around 33"s. What...
I was adjusting the exhaust valves today on my f-head and pulled the manifold off to make it easier. When doing this the far left (when you're...
Separate names with a comma.