I am winterizing my jeep before it gets any colder up here. Instead of a block heater I am using something that warms the coolant, I believe it's...
Anyone swap a chevy 4.3 liter in to a cj. I am having the tranmission transfercase and overdrive rebuilt. While I am doing this I have decided it...
I have the head pulled off and right now I am cleaning up the surfaces and will be checking for flatness. When I am reassembling this what do I...
I tried FLAPS, and North Star willys as well as vintagejeepparts. No one has cyllinder head bolts. Does anyone know where I can find some or worse...
When I start my jeep after it has been sitting over night it it emits a cloud of white steam/vapor from the exhaust. The white cloud produced...
I replaced the water pump a few months ago and I finally got around to plumbing the heater yesterday. I also decided I should replace my radiator...
How much should I expect to pay to have the tranmission and transfer case rebuilt. I am also assuming that I should replace the clutch while...
Does anyone know what the size/thread/length is for the screw that attaches the oil filler tube thing to the engine block(F134). It is located...
I just had a rollcage made and I started painting it yesterday. First we cleaned the cage with mineral spirits, then primed it. We put on two...
I have a milemarker 8000lb winch that I am mounting to the front of my 64. I don't like to buy premanufactured "stuff" if I don't have to. So I...
In August I am moving to Fairbanks Alaska. What do I need to do in order to keep it running during the cold winter months. I know I will...
I am trying to reconnect my vacuum gauge. First where does it connect to the engine. Second. Wat type of line do I use. If I recall when I...
I started the jeep up this mornig and went back inside for a few minutes. When I came out I noticed coolant running out from underneath the jeep....
I finally have the jeep running after 8 years in storage and it was good for awhile. The problem is now that when I turn off the ignition...
Does anyone use any type of fuel additive to clean the fuel system or for any other reason?
Take a look at these pictures and tell me what you think about the strength of the connectors. My dad and I built this half cage ten years ago...
I finally finished my disc brake conversion. So there I was standing in the driveway ready to test drive the jeep, grinning ear to ear First I do...
I am doing the Herm dual chamber conversion and adding disc brakes. I have the brakes on but am having problems with the master cylinder. I do not...
I am getting close to being done with my four wheel disc conversion, and now I am wondering Rubber or steel(for the brake hoses). I am tempted to...
I am in the middle of converting my cj to 4 wheel discs. The question I have is when running the lines to the rear calipers do I need to drop the...
Separate names with a comma.