Hummmm, I have seen that ad before. I don't know where I saw this but not on Atlanta Craigslist.
I have seen 401s' here from time to time but they said "why pay the big bucks for a rare engine when you can get decent power from a 360". They...
In my area a 360 is cheaper and more plentiful than the 304's. I purchased a 360, rebuilt is then sold the 304.
Results are in. 477 HP 432 FP Torque @6500. Interesting build, Probally worth while watching even for a stock build since they go thru some of...
A couple of months back they did a Buick 350. Might be of interest to some Jeepers. I sent an E-Mail asking for a F 134 but never heard anything.
Horsepower TV will be building a AMC 360 on next weeks show. What's interesting is they typically finish with a dyno run so you get some real...
For paint stripping I used a combination. I went over the surface rather quickly with a DA and a 36 grit pad and scratched the surface. I then...
I don't know what bell you have, I'm guessing the 360 is not original so couldn't guess what bell you have. I believe the bell is interchangeable...
A little more information would be helpful, a T15 D20 would be an OK low cost 3 speed option. A T18 D20 or D300 would be a stronger 4 speed option...
I ran mine n with the radiator just setting there but be really careful. fan could get into radiator.
I used some composite decking material. It was too thick so I had to rip it to the correct width and thickness but I would have used the bungee...
I have done it in an attached garage. I put plastic over the door joining the garage to the house, wife complained it really stunk up the house. I...
Interesting thread, I checked the sensors on the link posted and all seem to be permanent instillations. Any that are portable and used like a...
If you are at TDC compression both rockers will be in the neutral position, both valves will be closed. if TDC exhaust, 1 rocker will be down...
No it's not unusual. As mentioned 1st and reverse are not synchronized. Some of the shifter knobs show the shift pattern as L-1-2-3.
Is this what you would reccomend ?...
Thanks, I'll check the snap on- online.
Does anyone know a source for really good pliers to remove the split rings on a T18 front and rear bearing. The larger rings on the bearings...
X 2, I had some made in Albuquerque, thew were about the same price as off the shelf at Pep Boys.
You asked about vacuum in the tube from the oil fill tube to the air filter. There should not be vacuum there. That is a vent tube that allows...
Separate names with a comma.