I really don't know, but man, that would be some hauler!:eek:
I couldn't get ospho without ordering it, so being the impatient son-of-a-gun I am, I use a product called Extend. It applies the same and reacts...
Hah! Got mine on in one day! But then the tub was off, it was warm and dry enough, so I shouldn't have had any excuses. R) It took me a tad longer...
I have the magnetic type, but they are a PITA to me. :mad: Others may disagree. I plan on using diodes at the tail lights and wiring forward to...
Thanks Nick, I might take you up on that:) Most of my parts have come from Jeepguy. I think you know him. He's done right by me.
Drive it! R) I do have some steps to install so Wifey can get in since it is too high for her, and some minor steering issues to iron out. The...
Finally got fed up with the way my V6 with the DualJet ran, so I disassembled the carb and cleaned out all the trash. Went to NAPA, bought their...
Sparky, considering all the work and effort you have put into yours, I would think you'd be more than hopping :mad: :mad: if some bozo yanked it...
Mine is usually in my locked shop, guarded by my fierce bird dog, :twisted: and that is behind a fence. If I didn't have all that and planned to...
Don't know if this will help or not, but my spring goes right back to the bracket the cable is on. Seems to work when the carb is working, which...
Any way you can disconnect the line from the MC, plug it and try? That would tell you if it was bad, or something down line. Elimintate the...
My guess would be Krage, because I gave my leftover shims to another jeeper. Sorry, you could have had these. :( I didn'thave my races seated...
Russ, To increase the torque on the knuckle, remove. Conversley,add to decrease the torque. Yep, you have to remove the seal. The manual...
:oops: Hate to admit it, but I've done much worse!:oops: :roll:
:iagree: For that price, it wouldn't pay to do all the cleaning and sealing. Which in my opinion wouldn't get ALL of the rust out, leading to...
My besttop has snaps only on the tailgate. The rest of it is held in with a tab. Once everything is set, it works well.
The horn in my '60 is mounted behind the grill, right side. Won't say for sure if that is the correct place, but that is what I have. Mine has...
I put one on my '60, glad I did too. Pretty darn easy if you happen to have the tub off, otherwise it could be a little bit of a pain. Yeah, Herm...
I crawled under mine, scraped what I could off with a putty knife then went after it with a pressure washer. Still a non fun job. Maybe a few...
I tend to put the hubs in long before I get stuck, so when I finally do end up in slop, I'm REALLY stuck!R) R)
Separate names with a comma.