Hi My Tcase Leaks oil out the the shaft seal . I put a rebuild kit in with national seals. And it still leaks. So I replaced the seal again with a...
HEY I'm getting ready to swap my T90 3spd for a T98 4spd. After about 10 years of searching I have all the major parts. I'm looking for any...
Hi , I am a big fan of the little 4 , Ive had many of them over the years . One thing troubles me though the center cam journal sits directly in...
Hi one more ? I have 2 imput shafts one is 1 and 1/8 10 spline, the other 15/16 ,10 spline which one do I use for the F134? Thanks
DonX , I've been trying to call the # you gave me and all it does is ring could you check it and send it to me again thanks
Hi Thanks hawk nice pic thats the one. If you could give me as many dimensions as possible I would appreciate it. Timgr those are the parts...
Hi I've been looking for a front bearing retainer for a T98 for over 2 yrs with no luck. So i have decided to make one . Does anyone have...
Thanks sounds like I need a jeep main shaft.
Thanks for the input. Can I adapt the output shaft?
Hi I want to replace my T98 with a T18 is the adapter plate between the transmissoin and transfercase the same ? Thanks
hi I want to put a 4cyl diesel in my cj im thinking of the vw engine does anyone know of an adapter for this or any diesel engine thanks
hi ,i have heard that internal parts of a t18 and a t98 are the same ? if so is the reverse idler the same? thanks ,also are the throw out...
hi thanks for the input Kamel would you sell me a clutch kit for the t98 ?
hi,is a t98 clutch disc different than a t90? i havent found a listing for the t98 trans,the input shaft is a ten spline 1 1/16 diameter i...
i think your right looks like the parts i have are for a v6 any idea where i can get the 4cyl parts thanks
hi the front bearing in a t98 is it a tapered roller bearing ? my bearing retainer is not machined for a race like im familiar with it also does...
thanks for the input im going to keep looking and maybe fabricate what i need for now ill drive the m38a1
yes i need the input shaft and retainer i have the bell adapter to t case already any help with parts will be appreciated thanks
hi , timgr i have a t98 in a 1968 cj5 with 134f & d18 problem is i need an input shaft and front bearing retainer and cant find parts ive...
hi does a t18 4spd have the same front bolt pattern as a t98 and will a d18 bolt to the back thanks
Separate names with a comma.