I'm about to put my 225 back in my 2a and am trying to decide what carb to use. The motor is stock other than a DUI distributor and headers. I...
Yup, I have a tom woods 1310 yoke for the 20. I will most likely go with the WT 30/20. What I should do, is buy big boy axles for my 86 and...
I considered that also but was trying to go low buck. Won't a cv shaft help enough with angle issues? Can I still use the factory 47 crossmember...
I will not be running the Dana18, I already pulled it and will use Dana 20. I am still in the air about which tranny, maybe a t176. It's a shame...
I have been looking at different routes to take for an axle swap. Is the WT Dana 30/amc 20 the easiest swap? I found a set of scout 44s for $250...
I think I will go with them. The mounts that are in it now are from a CJ5 I believe and are kinda crappy looking. thanks
Looks like what's happening is the gear in the starter is not pulling/disengaging fully and getting chewed up by the flywheel. You are looking at...
I am pulling my 225 out to replace the existing motor mounts. The PO had done the swap and the welds and placement are ugly. Has anyone...
Yeah, that was kinda what I thought. I didn't think there was that much difference in the overall width though, dang. My main concern was...
I have an opportunity to get a complete Scout II Dana 44 axle with the auto hubs for $265, or less without the hubs. Will that axle be an ok...
I wish I could say that was the case. The PO did a hack job with the SOA, left the old SUA perches on and welded shock mounts to them. I have...
Thanks, the thing does look sweet, just need to get it driveable.
I have had this almost two years now and have only gave it a spray bomb paint job, some tires and have gathered up parts. Now it is time to set a...
Thanks. The round protrusions are flip up tie downs inside the trailer, there are a few all the way around and come in handy for holding down...
Looks good, inspires me to start working on mine!:beer:
Here are a couple pics of my Canadian military 101 trailer. I have definitely got my moneys worth out of it since picking it up about four years...
Sorry, I just found my answers in another section. Disregard this post, thanks.
I was at a Jeep show this past weekend and picked up an Edelbrock Performer intake manifold with a Holley 4 barrel mounted on top. The carb needs...
I don't have the toolbox in mine anymore but it may end up under the seat as well. I think I am going to just run them and use a slightly bigger...
I am trying to re-locate my battery to make some room and clean things up a bit. The engine bay is too tight with the 225 for my new battery. Plus...
Separate names with a comma.