Thanks everyone and for the photo Boopie. It looks like your column is close to 40 degrees but the big difference is the height at the dash. It...
[ATTACH] [ATTACH] [ATTACH]
I took these photos to illustrate the problem. The first one shows the original 52 degree angle to the column and the bus-like wheel position....
I currently have two tanks. I have a Conn Ferr tank in the rear. Maybe I ditch the stock tank.
Thanks for the input, all. You're right about the overstuffed seat boopiejones. Seating height needs to come down. If I lower the column on the...
This column angle is 42 degrees and it exits in a similar place on the firewall as it did on the intermediate long nose tub I have. Some of this...
By the way. This jeep came from Eldorado county in CA. Someone here might remember it. It has a 3" mandrel bent cage which makes it look like a...
The shaft has about 5/8" of clearance to the center pipe on the header and this is the tightest place. The pillow block will mount on the frame...
Here's the column and pedal position mocked up. You can see the original column mount used for the tilt column. [ATTACH]
Here's the driving position[ATTACH]
I bought this project quite awhile ago with a frame that had been wheeled hard and had patches welded over patches. It seemed easier to start...
...if any. I've seen a few on this site and I've seen the grill overlays for the intermediate, larger parking light, versions but I haven't been...
Thanks for sharing Tarry. I imagine like most long term owners their rides evolve with them. The only time we stop is if we sell 'em. It's a...
I have recently acquired a ‘64 Willys CJ-5 that was probably first modified in the 70's. Like many of the cj's I've seen, it is a homogenizing of...
Separate names with a comma.