This is what I did. Just use a stock cover from a Ford front D44. Don't know if a Chevy or Dodge has the high fill or not.
I've got the wide ratio T-18 and a TeraLow kit and it works great. With 4.56 gears it's about mid-90's crawl ratio which works well even in rocks...
Real bad advice in some states. Here in Colorado, the State Patrol inspects vehicles in the situations described, and could impound a vehicle that...
IMHO, the three speed is worthless for a rig that will see anything more than minimal, extremely easy, offroad use. The gearing is just too high....
I've run both, a lot, and the only significant difference I saw for a trail rig is that the Aussie is a lot noiser than the Detroit. It clicks a...
If you're not going to be airing down to where you need to worry about unseating a bead, beadlocks are a waste of money. They serve a pretty...
Flexplates do wear out, sounds like that's what happened to you. High horsepower/torque is the normal culprit but driving style can accelerate it,...
I'd recommend you throw the revolvers into the closest trash can and stick with regular shackles. The revolvers unload at unpredictable times and...
I'm running 35's with 4.5" of lift. Had to cut the rear fenders, but the fronts seem to be OK so far. It may change when the springs break in.
Why not just rotate the rear diff and install a CV rear shaft? It's way cheaper than a high-9 rear and works just as well. D44 disk brake kits...
One thing to note about the connectors with adhesive, they're incredibly expensive compared to plain (non-jacketed) connectors and weatherproof...
It is amazing how many of the stock connectors are actually available through Napa, Del City, and Centech, but you may never find them by...
If you want to mix and match masters and slaves, you need to dig around the web and get familiar with basic hydraulic power transfer. You need to...
It's you Jeep, do whatever you want to do. Just keep in mind that original sheetmetal is getting hard to find. If you want to hack something up, I...
If you're happy with the way it performs now, going to 31X10.50's won't make any difference.
I installed mine finally. 1.25" from Spidertrax. Just enough to get the tires away from the suspension, they made a huge improvement in...
You got more ambition than I do R) Good luck with the work, it'll be interesting to see how it turns out:lurk:
I'm not familiar with the RTS term, but the 4-speed OD tranny has very few fans. It's been a very long time since I dealt with one, but IIRC, it's...
The Electrac was junk from the moment it was released. TracTec (the Detroit people before Eaton bought them) wisely quit making them after about...
Sounds like you have a bad gauge or sender (or related wiring) if it doesn't read within a couple degrees of a thermometer stuck in the radiator.
Separate names with a comma.