I did a disc/disc swap on my '73 CJ5 last year. Rear calipers were Eldorado, with parking brake. I got the calipers from somebody else's...
Well, I'm really not THAT excited about it. Radiator on my '73 CJ5 (258/manual) is shot. What is the good and bad of replacement radiators?...
After several years running propane, I am going back to a carb. *Somewhere* in my shop I should have the old fuel pump and hard fuel line...but...
The steering wheel on my '73 CJ5 is in right poor shape...turns my hands black even when it's dry outside (used to just do it when wet). I have...
OK, got my '73 CJ-5 axle back from having a Detroit swapped in. Dumped in a couple of quarts of gear oil...then two more, four total, and it's...
OK, here's the deal. I scored a set of Scout axles (30/44) with an aftermarket disc brake conversion (SteelTech Solutions, now out of business)....
I did some horse trading and got a set of Scout axles (D30/D44) and am swapping the discs (4 wheel) over to my 1973 CJ-5. Calipers are mid-80's...
Since I'm running 'pane now, I'm going to remove the gas tank from my 1973 CJ-5. It is still solid, no rust, etc. No, it will no be for sale....
I'm not sure if the PCV hoses go to the right places on my '73 CJ5 with 258. Coming off the valve cover, I have 2 hoses, one is connected to...
What is the general opinion of the electric lockers, either ECTED or ELocker? I'm looking at an OX for the rear, but got to wondering about the...
I got a 258 in a '74 CJ5 that the PO put HEI on. What's the recommended plug gap and timing advance for this setup?
I got a '73 with a 258 swap (did have 232). Also did HEI conversion. I have onboard air (York compressor) and what with the home grown...
I'm going to go propane on my 73 (yes, I know the disadvantages). I'm looking at 2 43.5# forklift tanks, mounted behind the seats. Does...
I got a '73 CJ5, and thinking about lockers and such. I do like the look, handling and stance of the stock width axles. It works for me. I...
I want to replace my 1973 fuel and temp gauges with 2-1/16 gauges. What are the output ranges (ohms) for the stock sending units?
Separate names with a comma.