Cant seem to find any listing for u-joints for a pto shaft for my 61 with the winch..The local idiots wont open a book and look , if its not in...
Damn-it....Runs fine completly redone wont shift ..I tried to pull it in low range ,,bump the starter while in gear..2lb sledge hammer wont come...
Is there any way to check the fuel and amp guages without installing them on a Jeep// Cleaning house again and ran across four old style...
I replaced everything today on a 1963 CJ5 for my winter resto project.. anyhow new wheel cyclinders..lines .hoses..master cyclinder.. Cant...
Okay guys and gals ..who has the books to tell me what color I need to by for my 63 heres the tag numbers : PAINT TRIM...
Got a tuff one ...I tried everything from a pully puller to a 2 lb sledge hammer ..I hate to put the heat to it BUT.......I cant get the rear yoke...
Need to remove , looks like roof coating on the inside floor pans ,so I will be able to get it painted...It was put there so it wouldnt rust other...
Anybody have an idea where I can get or check the actual identity of the serial number on my cj2a or the boss number on the engine...I tried...
I have a 65 cj5 ..It has three different tire sizes on it..I would like to keep it as stock as possible, any ideas on the PROPER tires that are...
Anybody have an easy way to remove old shackle bushings out of the front and rear leaf springs on a 65.cj5..These are steel bushings not brass../...
Been restoreing M38A1 ( 1952) getting to be road worthy soon but.. Put brand new carb on .. LEAKS out the bottom float rod.. Went back got another...
Crawled underneath over the weekend wanted to see what kind of axles and tranny I got... CANT FIGURE THEM OUT.. front axle and rear axle have no...
Separate names with a comma.